LG 50PQ3000 Fixed No Standby Light

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Ukdigger
    Senior Member
    • May 2020
    • 121
    • England
    #1

    LG 50PQ3000 Fixed No Standby Light

    LG 50PQ3000
    Opened this TV and it looked like someone had emptied a hoover bag over all the boards. I cleaned all the boards front and back and noticed the main fuse on the power board had failed. I couldn't see any bad caps so I replaced the fuse and the TV worked with no problems, all voltages were good.
    Tags: None
    • nomoresonys
      Badcaps Legend
      • Jan 2013
      • 12206
      • U.S.
      #2
      Re: LG 50PQ3000 Fixed No Standby Light

      I try to blow the dust out of all my electronics about once a month with my shopvac.
      Quit because THIS SITE LETS A ROGUE MEMBER TYPE ANY GARBAGE HE PLEASES AND THE POWERS THAT BE NEVER DO ANYTHING ABOUT IT SO HE NEVER QUITS. THEN YOU GET A PENALTY FOR RESPONDING TO HIS ATTACKS. BEEN GOING ON FOR WAY TOO LONG. DONE SUPPORTING A SITE THAT ALLOWS THIS BS.

        Comment

        Previous template Next

        Related Topics

        Collapse
        • ChristianBr01
          LED TV Samsung The Frame 55 inch QE55LS03RAU Standby Light only
          by ChristianBr01
          Hello everyone,
          I got a Samsung The Frame 55 inch TV for free from uncle cause it is not turning on anymore. I am in the second year of training as an electrician so I have knowledge already but I am far away from to be a pro.
          The TV has Standby but ist not turning on. A Friend of mine owns a 50 inch Frame TV so I checked the One Connect Box and the One Connect Cable there. Both are good and working normally. I have opened the TV case and measured some voltages on the Board.
          What I already found is that the 12.8V are not an the connector to the main board connector to the power...
          04-23-2025, 01:48 AM
        • AleMonti
          LG 55EG910V - no power and no standby light
          by AleMonti
          Hi everyone,
          I'm trying to troubleshoot and repair this old LG OLED curved TV, model 55EG910V.
          I did some basic troubleshooting and reviewed most related posts here, but I wasn't able to isolate the issue.

          The TV shut itself off during playback and never came back to life - the standby light remains off. My dad claims that it has happened a few times in the past but the issue resolved itself after some time. Not this one.

          After checking the basics I did the following:
          • I measured all voltages and as expected the only active supply is the 3.5V standby. It
          ...
          11-04-2024, 05:02 PM
        • Kaar3l
          Samsung QLED QE65Q7FNAT only standby light
          by Kaar3l
          TV: Samsung QLED QE65Q7FNAT
          PSU: BN4400940A
          MB: BN94-12832K

          I got the tv in spring 2024. At that time it started, then ran 60 sec and poweroff. Seemed like reboot issue. I didn't have time and room to check it in summer so I plugged it in and now the standby light is on. I press button on remote, standby light goes off and tries to start?. No picture or backlight on LCD. I thought about removing diodes like in this thread: https://www.badcaps.net/forum/troubl...sung-qled-q60r...
          09-24-2024, 01:35 PM
        • jasonbay13
          Philips 37HFL5682L/F7 no standby light, incomplete service manual?
          by jasonbay13
          picked up a tv and when the power is plugged, the standby light flashes real quick then goes off. of 3.3, 12, 24v is all there but i couldnt find any 5v on the back-end board. ON/OFF is low, which it seems is what turns on the backlight so i removed the wire at the back-end board and put a 10k resistor to the 3.3v, which when plugged in brings on the backlight for a split second and also a blue light "LED1" on the inverter board, which goes off after a short time.
          am i missing something to bring on the backlight or is the inverter/ccfl gone bad? would that cause the inverter board...
          http://cerealbargain.duckdns.org
          12-01-2023, 09:55 PM
        • Nicktronic
          Samsung UN70NU6070F Standby Light flashes twice
          by Nicktronic
          Hey Everyone,

          So I've got this Samsung and the reported issue is that when powered on the backlight comes on, but no picture, no sound, it will flicker, the standby light will flash red twice and repeat the whole process...each loop lasts about 15 seconds.

          I've googled the issue and understand it is likely a panel/driver board issue, but was hoping the "tape method" could be successful. Before I did that though, I disconnected the left LVDS cable and powered the TV on. This time I got sound, no picture and the two blink standby light stopped. Did the same...
          03-27-2023, 07:01 PM
        • Loading...
        • No more items.
        Working...