I got this for free because the recycle place said it didn't work. Got it home and seemed to work fine. It played great as I kept it on for about 4 hours trying to see whats wrong. Shut it off and then immediately turned it back on. Guess what? No sound. Tried the same scenario with different sources and got the same result. Only get sound again if I let the tv sit for a while. I'm suspecting main board but wanted a few suggestions before I purchase another one. Thanks in advance
Vizio D55-F2 audio problem
Collapse
X
-
Tags: None
-
Re: Vizio D55-F2 audio problem
a few things to try if you didn't already, tv unplugged press and hold power button on tv for 30 seconds, factory reset, firmware update, did you see if the external speaker or headphone part works if equipped, that is during the fault condition?Last edited by nomoresonys; 04-08-2022, 10:30 AM.
Related Topics
Collapse
-
so i took out one of my spare gigabyte ep35-ds3r mobos from storage for use to do some cpu, ram and video card testing of stuff i bought from ebay and got for free from momaka. he bought 50 e8400 cpus for cheap from ebay some years ago and i decided to help him relieve him of some of his supply since he had waaaay too many!!
what did we say about hoarding too much stuff and depriving others of them?! *cough* socialism *cough* lol! 
i had to blow some dust off the board and heatsinks with the datavac as i didnt clean it up before putting it in storage. after finishing...-
Channel: General Computer & Tech Discussion
-
-
by falcontechGood Afternoon
I have a problem with this MOTU audio card, a traveler MK3, the connection to the computer is via firewire, the card is recognized by the computer (both mac and win) but I have no audio output, on the front there are a series of LEDs including the clock (44.1, 48, etc.) and that LED at the time of connection usually remains fixed telling me the clock frequency set on the computer, now at every start the LED in question remains flashing in most cases, sometimes it becomes fixed, other times it disappears, without any sign of operation, I exclude problems with the firewire chip,...-
Channel: Troubleshooting Audio Equipment
-
-
by i_am_patchHi All. I had a Roland KR-3500 Digital Piano (similar to the KR-4500) that exhibited a Crackling audio sound on all keys. After reading somewhere about someone with a similar issue who had replaced all the Electrolytic caps I decided to also go down that route. (Spoiler : It worked !) After some basic troubleshooting I determined that it could be noise feeding thru from the Keyboard scanning since the Demo tunes played back undistorted and the Audio amp / speakers were fine ( Inserted an Audio signal into the rear Audio input). After extracting the main board from the shield, I replaced 7 Capacitors...
-
Channel: Troubleshooting Audio Equipment
04-30-2024, 08:20 PM -
-
by hugocarmoHi.
I´ve been given an old CRT from Panasonic, it´s almost new, it was storaged and almost not used since bought.
It is imaculate inside, almost no dust or debris inside.
The picture is good, but I have no left sound channel, I tried all the inputs, outputs, even on headphone jack. In AV2 I hear sound from right channel but no image, on tv tuner only right sound channel, the same for AV1.
So I started to look for a service manual, I found one, and started from the beginning.
Most of the times the caps are the problem so I orderer all the caps for all boards,... -
by JRadeWhen I select the FM receiver, I find a radio station, the sound is heard on REC OUT(L,R), REC TAPE1(L,R),REC TAPE2(L,R) on high-ohm headphones, the sound regulation does not work.
The output reacts when I connect the record player to PRE OUT FRONT L, the sound is heard in the speaker but the sound regulation does not work. Then it does not matter what I chose on the front selector.
I replaced the capacitor C303/0.047F, nothing changes.
I'm asking for help, what should I do next?
Thanks in advance!...-
Channel: Troubleshooting Audio Equipment
-
- Loading...
- No more items.
Comment