Rebooting tv, will not take firmware, tried changing the file name to upgrade_loader.pgk still will not take. Any other ideas?
-
-
Re: Xbr65x900c
Sounds like a failure which will require the module to be serviced or replaced. If this is already a new module then follow the instructions in the video linked below:
https://youtu.be/3kYPjIHt8Lc
If you still have issues after following all the instructions then your module will most likely need to be serviced or replaced again.
It is possible to break your board if you do not perform the update/pairing properly. Follow instructions!
Good luck -
Re: Xbr65x900c
thanks will tryComment
-
Re: Xbr65x900c
so sony finally came through and replaced main bd for free up and running now. extended warranty ends Dec 30th.Comment
-
Hi, I have a Samsung UE50TU with:
- sound and backlight, but no picture
- when it arrived, it had a picture for a few seconds
- it keeps rebooting
- without ribbon cable between the two panel boards, it does not reboot but I have no picture
- without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
- when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.
- without cable between mainboard and lcd panel and with a jumpered... -
Hi all.
I'm trying to fix my Samsung QE50Q60TA TV.
IT's rebooting every few seconds.
I have done some tests and it looks like it stops rebooting when I tape pin 46 (I thinks it's FB_1) on the ribbon tape that connects two boards atteched to screen, but nothing is visible, just backlight is solid and I can hear sound. Taping over other pins doesn't work.
Have also soldered two pins on the motherboard to check if I can get an image on the rights side of the tv, but it keeps rebooting.
Can anyone suggest what I can test and do to get it working again please?... -
Hello everyone, I'm working on a Samsung TV that constantly rebooting.
MB/PSU unit: BN9654185QE
It loads up to the main menu then as soon as the backlight goes brighter it reboots.
First I suspected the LCD panel, so a disconnected the LCD display from the mainboard but did the same thing.
Then I removed the backlight connector which only delayed the bootloop by a minute maybe, I know it because I test it with the remote, it does gives the menu sounds a bit longer.
Also I have to note, that the MB/PSU combo gives out a very noticible... -
Hello folks,
New to Audio equipment - I got this receiver, I connected speakers and I tried to connect to Bluetooth. My phone would not see the receiver (Receiver flashes the BT as if it's trying to pair). Then I put it on FM radio, I get white noise on the speakers. I click the +/- Tuner button, and it moves from saved station 1 through 28, but the frequency is 87.x MHz not changing. At this point, thinking I may need to do a FW upgrade, I connected an HDMI cable to the TV and TV reports "No Signal" - TV "Kind of" sees the receiver (When connected to greyed out port,... -
anyone have experience solving rebooting or blue screen without anything showing on display pannel.
on Samsung un85un900. 85in 8k qled display with one connect box.
I will upload some images if someone can pinpoint any diods or resister that could potentially go bad.
I see no trades or points for vgh or vhh or clock lines or anything that typica5teatwd on this TV.
it was rebooting but after removing some part of ribbon that stops....
Comment