Panasonic TX-L55ET5B wont turn on, flashing red light

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Bloopeta
    Badcaps Veteran
    • Jun 2018
    • 526
    • United Kingdom

    #1

    Panasonic TX-L55ET5B wont turn on, flashing red light

    I have a Panasonic TX-L55ET5B that wont turn on.

    When you press the power switch on set, you get the blinking green light, then it goes solid, the display comes on and goes off 3 times, then it goes off completely and the power light slowly flashes red continuously.

    If I hold power button and turn it off, and back on, it does the same as above.

    When the display is on, there is a noticeable noise from inverter board, that is only audible when screen is illuminated, it goes off and back on with the screen.

    I have attached pics of rear and boards.

    Any help grately appreciated.
    Attached Files
  • neilc6
    Badcaps Legend
    • Nov 2015
    • 1550
    • Canada

    #2
    Re: Panasonic TX-L55ET5B wont turn on, flashing red light

    Google for a service manual. Panasonics typically will blink an error code.

    Comment

    • Bloopeta
      Badcaps Veteran
      • Jun 2018
      • 526
      • United Kingdom

      #3
      Re: Panasonic TX-L55ET5B wont turn on, flashing red light

      Originally posted by neilc6
      Google for a service manual. Panasonics typically will blink an error code.
      I already have done, but mine just blinks continuously forever, the error code blinks only go up to 25

      Comment

      • Bloopeta
        Badcaps Veteran
        • Jun 2018
        • 526
        • United Kingdom

        #4
        Re: Panasonic TX-L55ET5B wont turn on, flashing red light

        The noise when display comes on is coming from one of these in attached picture, think the far right one.

        Its quite a high pitched noise and quite loud
        Attached Files

        Comment

        • zomi
          Badcaps Veteran
          • Nov 2011
          • 505

          #5
          Re: Panasonic TX-L55ET5B wont turn on, flashing red light

          Edge lit tv
          But backlights do go on these as well.

          Comment

          • Bloopeta
            Badcaps Veteran
            • Jun 2018
            • 526
            • United Kingdom

            #6
            Re: Panasonic TX-L55ET5B wont turn on, flashing red light

            Originally posted by zomi
            Edge lit tv
            But backlights do go on these as well.
            Is that likely to be the problem?

            Comment

            • zomi
              Badcaps Veteran
              • Nov 2011
              • 505

              #7
              Re: Panasonic TX-L55ET5B wont turn on, flashing red light

              I would check the leds using a led tester
              from the connectors first without having to take it apart first.

              also check voltages at the led inverter there

              Comment

              • Bloopeta
                Badcaps Veteran
                • Jun 2018
                • 526
                • United Kingdom

                #8
                Re: Panasonic TX-L55ET5B wont turn on, flashing red light

                Originally posted by zomi
                I would check the leds using a led tester
                from the connectors first without having to take it apart first.

                also check voltages at the led inverter there
                Will do thanks, do you by chance know what the readings should be??

                Comment

                • zomi
                  Badcaps Veteran
                  • Nov 2011
                  • 505

                  #9
                  Re: Panasonic TX-L55ET5B wont turn on, flashing red light

                  service manual is here

                  https://www.manualslib.com/manual/10...page=17#manual

                  its seems for 3 blinks

                  A -board
                  P -board

                  Comment

                  • Nick's Tvs
                    Badcaps Veteran
                    • Jan 2014
                    • 621
                    • USA

                    #10
                    Re: Panasonic TX-L55ET5B wont turn on, flashing red light

                    We have seen a few of these come in to the shop, main board generally get's the good old cracked joints on the BGA chip for this model.
                    remove the heatsink on the main board, heat up the BGA chip with hot air, see if that temporarily fixes your issue.
                    Often when the main boards go bad, they won't self diagnose properly and then won't throw the correct error codes, or won't throw an error code at all.

                    Comment

                    Related Topics

                    Collapse

                    • esqmooo
                      HP Elitebook 845 G8 dead, only caps lock flashing 7 times. Charging light always on
                      by esqmooo
                      Hello everyone.

                      This is my development machine. I've been using it since two years and half without any problem except sometimes it wouldn't wake up from sleep.
                      Lately the issue became more frequent and powering it up would take few seconds to show the POST screen.
                      Then the computer refuses to power on at all. Now only the caps lock button flashes 7 times then stops. The charging light is always on whenever a power source is connected (battery or charger).
                      I tried long pressing on the power button, after several seconds it would go off then when the button is released...
                      03-11-2025, 03:57 PM
                    • learnmore
                      Samsung QE55Q60TAUXXU - flashing backlight and flashing standy light--no image
                      by learnmore
                      Hello Community!

                      CASE DETAILS

                      Promblem Signs: Backlight on 1 sec off 7sec > repeat && Red standby light: 1blink, off 3 sec, 2 blinks, off 5 secs, 2 blinks, off 3 sec, restart cycle

                      13V present on powerboard output. Backlight continues flashing after removing cables to pannel one at a time and even with both disconnected. NOTE: backlight STOPs flashing and remains on when connector between powerboard and mainboard (note Tcon built in) is disconnected.

                      Tried inserting firmware on USB and left it in for a few hours, but no change
                      ...
                      03-03-2024, 09:49 AM
                    • Adogabriel100
                      Macbook pro A1278 820-2936 No light/turn on
                      by Adogabriel100
                      Hey! how are you guys? i wonder if you could help me with this macbook 820-2936 that does not turn on. (Doesn't have green/orange light).

                      History:
                      this macbook came for a short on C6990 that blows D6990 and R6990 on his way. i re-placed the componets and it work again.

                      A month later comes back again and has the actual problem (no green/orange light and dont turn on)

                      The macbook can turn on with only the battery connected but in fact, dosent charge.

                      Voltajes:

                      PP3V42_G3H = 3.3v
                      PPBUS_G3H = 12.2V
                      PM_PWRBTN_L...
                      06-28-2023, 07:41 PM
                    • stephonwhyte
                      un65tu7000fxza - Flashing Red Power Light
                      by stephonwhyte
                      un65tu7000fxza - I am experiencing the flashing red light on the power led. So I purchased the replacement kit for the mainboard and power supply. I still experienced the flash red power light. So I purchased a new ribbon cable, The flashing light stopped for a minute, I could hear sounds on the TV but no picture. I did the 60 second reset and it went back to flashing. What could possibly be the issue now? All the LEDs are lit up from what I can see.

                      Thanks for all responses.
                      11-22-2022, 12:03 PM
                    • Bloopeta
                      JVC LT-43C890(a) wont turn on, flashing red light
                      by Bloopeta
                      Have a JVC LT-43C890(a) that no longer turns on, just red flashing standby light.

                      Just wondering if its likely to be Power or Main board? All caps etc look good ok on quick visual inspection.

                      Also, when sourcing replacement power boards for these Vestels, do all numbers need to match? Or just the main generic board no. (i.e. 17IPS72)...
                      01-11-2022, 12:01 PM
                    • Loading...
                    • No more items.
                    Working...