LG 55UH615 : panel problem, is it repairable?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • guix
    Member
    • May 2018
    • 25
    • France
    #1

    LG 55UH615 : panel problem, is it repairable?

    Hello all,

    I bought a tv LG 55UH615 that has no picture but sound and backlight working. As an amateur I though obviously that it was the TCON board so I bought one, but still no picture with the new one. I was about to buy a main board, but after a closer look I discovered there is a short circuit somewhere on the panel's right driver board (the one on the left, when looking from the back of the tv). Please look the attached video where I test for shorts on ceramic caps. There is no apparent damage, corrosion or traces of water, the COF looks fine, no traces of heat or burns...

    What can I do about it? Do I remove caps one by one, until the multimeter hopefully stops beeping ? Then I replace the bad cap(s)? If so, how to find their value if they are broken?

    Or is it most likely a problem with a COF, so I cannot fix it?

    I saw some youtube videos of people fixing their panel driver board by replacing damaged caps, but it was caused by water/corrosion damages so it was obvious, which is not my case.

    Thanks !
    Attached Files
    Last edited by guix; 03-09-2019, 12:42 PM.
    Tags: None
    • guix
      Member
      • May 2018
      • 25
      • France
      #2
      Re: LG 55UH615 : panel problem, is it repairable?

      Forgot to update

      As suspected, it was a bad cap at the bottom of the LCD panel, I replaced it using cheap "Yihua 938D smd hot tweezers", worked great, tv is repaired
      Last edited by guix; 03-08-2020, 05:31 AM.

        Comment

        Previous template Next

        Related Topics

        Collapse
        • perzyk23
          Lenovo T580 - LCD Panel problem - error 0288
          by perzyk23
          Good morning,
          I have a problem with Lenovo T580, which after error code 0288 suggests a problem with the display. I checked the display and it works on another laptop. I replaced the display cable with a new one. I programmed another BIOS (downloaded from this forum) and I still have the problem of a dead display - there is an image via HDMI, and the system does not detect the built-in LCD at all. The problem appears to be hardware. What can I check to confirm or disprove this? I found many threads on the Internet related to this problem 0288, but without specific solutions. Please advise....
          10-25-2024, 12:42 AM
        • x_orange90_x
          Busted panel corners... Repairable?
          by x_orange90_x
          I have a 50" Toshiba bezel-less that I replaced backlights in a few weeks ago. The tape didn't hold well so the panel started hanging from the top. The pressure caused the two bottom corners to shear off. I can see a court contact on the right corner, but the left is gone in assuming. The screen is not cracked anywhere else, but it displays no image.

          Is it at all repairable? I'm assuming not....
          02-02-2025, 04:17 PM
        • Davi.p
          Sony KDL-42W705B panel problem
          by Davi.p
          Hi, this has panel problem for certain (AUO panel), in the troubleshooting process, after pressing ON button i am with set making a short lamp of backlight with status light shortly white then green/yellow repeated, in this situation main board remain powered and also tcon with all their correct output voltages. I cant find in the service manual description of this state, can you brief me ? thanks
          01-26-2023, 07:56 AM
        • porfyriadhs
          LG 49UJ701V Panel problem
          by porfyriadhs
          Hello I have a tv with bad panel
          Brand LG 49uj701v. At first screen wasnt working only sound with backlight was working welll. The I tried tape at the lvds and it works but I get have image with shadoe
          10-05-2024, 06:18 AM
        • Storyteller12
          QN55Q60R Service Menu Panel Help
          by Storyteller12
          I had a the above tv qn55q60r that had a bad panel but everything else good. I had another panel here from un55nu6900 with bad leds and melted diffusers.

          I put the nu6900 panel in and powered it up and it does work but there are lines vertical lines.

          I was trying to change the panel type in the service menu but don’t see my exact panel. Anyway to fix this or someone have similar experience.

          the clear picture is the panel type from the service menus on the nu6900. The other 1 is the panel type that was set for the q60r with the bad panel....
          01-13-2024, 01:57 PM
        • Loading...
        • No more items.
        Working...