LC-52D62U Base Screw Size

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • jason123
    Badcaps Legend
    • Oct 2015
    • 1068
    • USA
    #1

    LC-52D62U Base Screw Size

    Folks,
    Does anyone know what screw size is needed to attach the base to this TV? I know they're Hex "Long" screws according to the manual. I'm guessing roughly around 2.5 inches long.. but anyone know the pitch and other specs?
    Thank you!
    Tags: None
    • R_J
      Badcaps Legend
      • Jun 2012
      • 9535
      • Canada
      #2
      Re: LC-52D62U Base Screw Size

      They could be M5 or M6 metric thread, the manual does'nt say what they are
      Attached Files
      Last edited by R_J; 06-12-2018, 12:04 PM.

        Comment

        • jason123
          Badcaps Legend
          • Oct 2015
          • 1068
          • USA
          #3
          Re: LC-52D62U Base Screw Size

          Thanks R J
          I went to the hardware store and grabbed a handful to try. These worked fine:
          M5-0.8 x 50 mm (though had I found a 60 mm I think it would have worked better)
          #10-32 x 2 1/4 also worked fine.

          Hope this helps someone in the future

            Comment

            Previous template Next

            Related Topics

            Collapse
            • howardc64
              A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
              by howardc64
              Problem

              This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
              08-04-2024, 10:36 PM
            • astroboypaul
              Surface Book 2 Performance Base dead
              by astroboypaul
              I'm working on a Surface Book 2 performance base (M1032224-004 on white sticker) and would love for some help troubleshooting or where to look next.

              The tablet when not connected to the base seems to work fine, but:
              • When tablet is off and connected to the base, it won't turn on.
              • Connecting tablet that is already on to base there is a windows device detected tone (not sure what device), but tablet remains in tablet mode, keyboard/trackpad don't work, and windows continues to report only 1 battery.
              • Charger white light turns on when connected to the base, but base battery and tablet
              ...
              04-25-2025, 12:40 AM
            • Prott
              PS5 - long screw damage, via to ground layer short?
              by Prott
              Hello dear Badcappers,
              I came across a PS5 that was longscrewed. The screw went through the HDMI IC (which I replaced + repaired the traces it damaged), however the screw also bend the board and slightly cracked it on the other side. It still seems like it could be fixable though as the area might not have lots of traces going through it (fingers crossed).

              Can somebody, please, measure their board and tell me if my assumption of an inner short between the via and ground layer is correct? These 3 pads have almost no resistance. I would like to make sure those are not some data...
              2 Photos
              07-27-2024, 08:54 AM
            • Document Archive
              HP EliteBook 830 G5 + Samsonite Base Boost Notebook 800 Specification for Upgrade or Repair
              by Document Archive
              This specification for the HP EliteBook 830 G5 + Samsonite Base Boost Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the 830 G5 + Samsonite Base Boost boardview and 830 G5 + Samsonite Base Boost schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties...
              09-06-2024, 09:00 AM
            • Document Archive
              Microsoft Surface Book Surface Book with Performance Base Hybrid (2-in-1) Specification for Upgrade or Repair
              by Document Archive
              This specification for the Microsoft Surface Book Surface Book with Performance Base Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Surface Book with Performance Base boardview and Surface Book with Performance Base schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please...
              09-06-2024, 08:20 AM
            • Loading...
            • No more items.
            Working...