Samsung un46eh boot loop

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • farnswerth
    Member
    • Mar 2013
    • 17
    • United States

    #21
    Re: Samsung un46eh boot loop

    I managed to get a hold of a tcon board, even though i had my doubts about that being the solution. But it worked, replaced the tcon board and it's been working (what I assume to be) properly for a couple hours now. Thanks to everyone for the help and guidance!

    Comment

    • budm
      Badcaps Legend
      • Feb 2010
      • 40746
      • USA

      #22
      Re: Samsung un46eh boot loop

      I am glad you got it working, this is a tough one since I cannot figure out why you can disconnect the LED backlights the you can turn the TV on and off and no boot-loop.
      Never stop learning
      Basic LCD TV and Monitor troubleshooting guides.
      http://www.badcaps.net/forum/showthr...956#post305956

      Voltage Regulator (LDO) testing:
      http://www.badcaps.net/forum/showthr...999#post300999

      Inverter testing using old CFL:
      http://www.badcaps.net/forum/showthr...er+testing+cfl

      Tear down pictures : Hit the ">" Show Albums and stories" on the left side
      http://s807.photobucket.com/user/budm/library/

      TV Factory reset codes listing:
      http://www.badcaps.net/forum/showthread.php?t=24809

      Comment

      • farnswerth
        Member
        • Mar 2013
        • 17
        • United States

        #23
        Re: Samsung un46eh boot loop

        Originally posted by budm
        I am glad you got it working, this is a tough one since I cannot figure out why you can disconnect the LED backlights the you can turn the TV on and off and no boot-loop.

        Thank you for your help! I'm glad it sounded like a weird problem to you also, I was wondering if it was going to be long and confusing to fix. If I knew more and had more tools I would investigate the bad t con board further, but I don't have those skills. I just hope this thread helps someone else with the same problem.

        Comment

        Related Topics

        Collapse

        • Takeatry
          Yet another Samsung QLED Boot Loop
          by Takeatry
          Samsung QLED QN50Q — purchased 2022 started experiencing a delay in the picture coming on in the morning less than 2 years later. Did not know the term boot loop at that time. As the loop delay ran into a few minutes did all the recommended troubleshooting, soft and hard reset, changing cables and outlet locations, no help. As the delay increased contacted Samsung tech group and allow them remote access the tv. Tech was moving too fast to see exactly what he was doing but this ultimately it was also no help. Lived with the delay until it stretched out over 6 hours. Pulled of off the back cover...
          10-04-2024, 02:57 PM
        • torchzack
          Samsung 55" TV - Boot loop but sometimes works fine - UE55MU6470U
          by torchzack
          Hi Team - just joined to see if anyone can offer some expertise in diagnosing an issue with a TV.

          I've done a few hours googling and youtubing but just seeing if anyone has any insight here. I got a 55" Samsung UE55MU6470U which seems to boot loop and then after 10 mins will boot, work for a few minutes, then turn off and repeat.

          Whilst it's on into the normal Samsung menu/boot screen it looks perfect - so I can't see there being any screen issues. I've seen lots of videos with taping across clock lines to diagnose which particular one may be an issue but i don't...
          08-28-2023, 07:42 AM
        • NolesFan
          Samsung un82ru88000f - Boot loop sort of but can correct with taping of LVDS ribbon
          by NolesFan
          Hello all... TV started boot looping. Opened the back panel and tried to isolate the problem. Just PSB no boot loop. PSB and MB no boot loop. Plug in the LVDS from panel to MB and boot looping starts up. It doesnt matter of order that I plug the LVDS ribbons back in, only 1 and no boot loop but as soon as 2nd one plugs in boot looping. I then noticed a flicker on the screen when I was closing the clip on the harness to the LVDS. Shut the lights off so I can see better, and I noticed as i slowly close it, I will get a picture, but as soon as it clips in, I lose picture and booting happens. So I...
          10-24-2024, 06:36 PM
        • eigma
          Samsung UN40H5003 boot loop every ~8 seconds
          by eigma
          Hi, I rescued a Samsung UN40H5003AF (H = 2014 FHD) from the curb. Symptoms are: standby (red) light comes on, stays on for 8 seconds, flickers off, then comes back on, and the cycle continues.

          Service manual: https://www.electronica-pt.com/esque...is-u8la-71272/

          SMPS board: checked voltages, all seem normal (A13V = 12.8V, UD = 3.3V, PWM_BLU = 0.77V, PS_OnOff = 5.5V). Remove 10p cable to main board -> backlight comes on. I think this means SMPS board and backlight are good.

          Main board: BN94-07592P / BN97-08922R...
          11-20-2024, 10:31 PM
        • THXFX
          samsung un43nu7100 BN94-13191C/BN41-02635A boot loop problem even with tcon jumper
          by THXFX
          Hi I need help with a Samsung un43nu7100 BN94-13191C/BN41-02635A with boot loop problem even with tcon jumper.
          I've already try tape method and same happen, if I disconnect both flex from mainboard to panel tv boots normal even I hear Samsung sound.
          When I solder jumper to make t-con work with or without panel or panel cables connected it still reboot or power cycling.
          What I noticed is that there's no voltage in VHG, HAVDD, PANEL_3.3V, AVDD_17V or 12v near dc-dc chip.
          I check capacitors and diodes and didn't find any short IN MAINBOARD.
          Measured all power supply...
          03-20-2024, 03:21 AM
        • Loading...
        • No more items.
        Working...