Hello everybody, I had a really bad experience today. my vga cable was stripped and it touched the metal case of a stereo that apparently wasn't grounded and it arced. before i knew what happened i went to unplug it and it arced again and all 3 tvs/monitors i had went dead. I killed the power and checked them 1 by one. One was dead dead. no power whatsoever. the 2nd one was still on but hdmi wasn't working. i tried vga and it worked. the 3rd one was my insignia tv. A dim little light was on but wasn't bright or off like it does when its on. I opened it up and checked the fuse. its still good. I checked pin 6 and 6 which are stby 5v and they are good. DOnt know where to take it from here. its feeding 5v to logic board but logic board not feeding back the turn on circuit. any way to trick it to check the power board and then i can concentrate on the logic board? anything i should check like test points?
please feel free to ask anything and i will gladly appreciate any help
thank you
tommy
please feel free to ask anything and i will gladly appreciate any help
thank you
tommy
Comment