Announcement

Collapse
No announcement yet.

LF501EM6F Emerson 50" tv

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    LF501EM6F Emerson 50" tv

    I have an LF501EM6F Emerson 50" tv with a main board model number BA4GU5G0201 4. I found two shorted caps on the back of the main board. C3825 and C3828.
    I am wondering if anyone has a board they can measure these caps on and let me know what they are? It might help someone else with one of these chirpers too. I measured 5.6uf on one I removed but it would be nice to have a little verification.
    Attached Files
    Tags: None
    #2
    Re: LF501EM6F Emerson 50" tv

    If you measured a shorted cap, then you wound't read anything good in value. C3824 and C3827 are parallel to the ones you took out. So measure these.

    Comment

      #3
      Re: LF501EM6F Emerson 50" tv

      Look like they are in parallel. If so they are probably same as other two
      I assume no responsibility for any stupid suggestions I might post.

      Comment

        #4
        Re: LF501EM6F Emerson 50" tv

        What is the resistance reading between the two pads on the board where the caps?
        It will not be showing 5.6uF if you have shorted cap, you can easily verify that by shorting you cap tester leads together to simulate shorted cap measurement.
        Never stop learning
        Basic LCD TV and Monitor troubleshooting guides.
        http://www.badcaps.net/forum/showthr...956#post305956

        Voltage Regulator (LDO) testing:
        http://www.badcaps.net/forum/showthr...999#post300999

        Inverter testing using old CFL:
        http://www.badcaps.net/forum/showthr...er+testing+cfl

        Tear down pictures : Hit the ">" Show Albums and stories" on the left side
        http://s807.photobucket.com/user/budm/library/

        TV Factory reset codes listing:
        http://www.badcaps.net/forum/showthread.php?t=24809

        Comment

          #5
          Re: LF501EM6F Emerson 50" tv

          No I pulled one of the others and then replaced it so it would not run away.

          Comment

            #6
            Re: LF501EM6F Emerson 50" tv

            I traced the line pulling and replacing components in the circuit until found the ones that were shorted to ground.

            Comment

              #7
              Re: LF501EM6F Emerson 50" tv

              So did you find the problem and which component was it?
              Willing to help but I'm no expert.

              Comment

                #8
                Re: LF501EM6F Emerson 50" tv

                I replaced C3825 and C3828 with 5uf caps. Tv is functional. You're mileage may vary.

                Comment

                Previous template Next
                Working...
                X