Anyone could sell SG6742HR ?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • PowerAmpFreak
    Badcaps Veteran
    • Feb 2010
    • 982
    • Sweden
    #1

    Anyone could sell SG6742HR ?

    Hi
    Anyone in europe want to sell a few SG6742HR PWM controllers used in Vestel powersupply 17IPS20.
    I can pay through paypal or similair

    Thanks in advance
    Tags: None
    • dick_barton
      Badcaps Legend
      • Aug 2015
      • 6643
      • Wales
      #2
      Re: Anyone could sell SG6742HR ?

      You can try Little Diode who I have used for hard to get parts.

      https://www.littlediode.com/components/

      Edit
      They are also available via Ebay
      Last edited by dick_barton; 02-02-2017, 04:21 AM.
      Willing to help but I'm no expert.

        Comment

        • PowerAmpFreak
          Badcaps Veteran
          • Feb 2010
          • 982
          • Sweden
          #3
          Re: Anyone could sell SG6742HR ?

          I was able to find a few!

            Comment

            Previous template Next

            Related Topics

            Collapse
            • eccerr0r
              Sell or Shim Solar panels?
              by eccerr0r
              Well, due to my grid tie inverter not accepting high voltages, and the fact that the lions in my solar panels are 36V (72-cell) I think I need to stick with 72-cell.

              However I have a few smaller panels that are 36, 32, and two 30-cell. The 36 and 32 together run at 75% efficiency (and subtract more with additional inefficiencies) when running in parallel with the 72-cell panels. The kicker is that the two 30s... generate 0% power when connected in parallel(!)

              So now what to do with these small panels?

              I could sell them...

              Or I could shim them....
              03-29-2025, 01:07 AM
            • sam_sam_sam
              They are closeing there doors for good when they sell out for inventory mpja.com/ sad to see them go
              by sam_sam_sam
              I have bought from them for many many years now

              https://www.mpja.com/...
              04-22-2025, 02:57 AM
            • Ublala Pung
              Lenovo V15 and V17-IIL and probably others with 10th or 11th gen CPU suffer from a design flaw
              by Ublala Pung
              The Lenovo laptops V15 and V17-IIL with I5 or i7 CPU and probably many other Lenovo laptop from this time with 10th or 11th generation Intel CPU suffer from a design flaw regarding the display/camera/microphone connector on the motherboard which is badly placed and the cheapest of the cheap connectors imaginable. As the cable is too near to the display and the connector does not fix it proper in place the cable develops little defects and those over time lead to a plethora of possible quirks or failures starting from the named RAM problem or sudden switching off in special when the display is...
              04-23-2025, 04:47 PM
            • karatzdi
              Denon AVR 1908, High pitch noise on Surround back Left channel after long overhaul
              by karatzdi
              Hello,

              I know some might say... just buy another one. Sell it as parts..!

              So had this AMP for quite some time. Recently I saw light smoke coming out of the AMP. Had my fire extinguisher close by. Just kidding. Turned immediately all devices off from mains.
              Let things cool a bit, and opened up the amp device. I clearly saw on the main board which hosts the 5X amp (5.1), 3 10 ohms 1W resistors had their leads looking black, while the rest of the remaining 2 x 10 ohms were brownish as being installed from factory.

              Spent some time downloading the Service...
              06-11-2024, 08:38 AM
            • YellowJacket
              SONY KD 55XD8005
              by YellowJacket
              Hi friends,
              i would like to ask for a little help, with SONY KD 55XD8005. This TV suddenly stopped working during playing. I figured out, there is 95% chance, the eMMC memory is corrupted ( based on some yt videos with similar models and some voltage measurements around the eMMC ). I have no programmer for such a memory. Is there anyone on the forum, who can program and sell the programmed eMMC for this board?. I would rather fix the original board, than buy a new one.

              Just for information:
              - the TV is dead, no reaction either to remote, or to power button on the TV...
              11-08-2025, 09:56 AM
            • Loading...
            • No more items.
            Working...