Got this TV set from my Dad, he replaced it with a new Sony Bravia so I figured I'd try to get it working.
Typical no power on situation, red standby light stays on.
Only thing that makes this a little different, that I havent seen mentioned elsewhere is if you leave it unplugged for several minutes, then plug it back in the set will turn on, and work for about 3-5 minutes, sometimes more sometimes less, then you hear multiple pops/clicks from the speakers and it shuts itself off (blue power LED turns back to red) and after that it will not turn back on unless you unplug it and do that whole dance again.
I replaced the power board since it was only $16 on eBay, now looking at the main board since the issue didn't get resolved. What is the best procedure for testing to make sure I'm replacing the correct parts?
Thanks All, I appreciate the help
Typical no power on situation, red standby light stays on.
Only thing that makes this a little different, that I havent seen mentioned elsewhere is if you leave it unplugged for several minutes, then plug it back in the set will turn on, and work for about 3-5 minutes, sometimes more sometimes less, then you hear multiple pops/clicks from the speakers and it shuts itself off (blue power LED turns back to red) and after that it will not turn back on unless you unplug it and do that whole dance again.
I replaced the power board since it was only $16 on eBay, now looking at the main board since the issue didn't get resolved. What is the best procedure for testing to make sure I'm replacing the correct parts?
Thanks All, I appreciate the help
Comment