Hi guys. I have a Sharp LCD tv with vertical lines. I suspect this is a TCON issue since I get lines through the menu when I press the menu button. Is this correct or could it be a main board or panel?
-
-
Re: Sharp LC-46D62U vertical lines
first clean the LVDS connectors between main and Tcon board. Then the cables from Tcon to LCD. See if something changes. -
Re: Sharp LC-46D62U vertical lines
I cleaned them and its still the sameComment
-
Re: Sharp LC-46D62U vertical lines
Disconnect one side of the tcon, check the picture then the same on the other side.Comment
-
Re: Sharp LC-46D62U vertical lines
This is the main board issues. Try to reflow the two chips on the main board. Search the threads on this forum.Comment
-
Re: Sharp LC-46D62U vertical lines
Budm provided the following pdf which may be of some help. Since the pattern is uniform I think it looks like that shown in Fig 4Willing to help but I'm no expert.Comment
-
Re: Sharp LC-46D62U vertical lines
Did you try heating (hair dryer) or cooling (can of air upside down) the Tcon and the main board while watching the screen?Comment
-
Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesnβt display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed... -
Hello,
i order a t-con because i had bad colors on my SONY KDL-40V3000 :
With the new t-con the color are good but there are vertical lines on all the screen :
I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)
Is there a way to fix the vertical lines on the new t-con ?
Thank you for your help
gpo23... -
ALL LCD LED TV SERVICE MENU CODES
Service Menu Code with Board Name
China Universal Board / Jumper Board Service Menu Code
Changhong Ruba Service Menu Code
Ecostar LED TV Service Menu Code
Orient LED TV Service Menu Code
Haier LED TV Service Menu Code
TCL LED TV Service Menu Code
Samsung LED TV Service Menu Code
LG LED TV Service Menu Code
Videocon LED TV Service Menu Code
Supra LED TV Service Menu Code
Toshiba LED TV Service Menu Code
Symphony LED TV Service Menu Code
Veste/ LED TV Service Menu Code...10-31-2024, 03:58 AM -
Thanks for offering your assistance with this. I'm an electronics enthusiast with moderate level of competence (have a decent lab with two power supplies, microscope, DSO, hot air, good iron, can competently work at a component level on SMDs, design and solder own PCBs etc). I really enjoying fixing things and learning new stuff so took up a free 58" LED TV and have been googling and watching Youtube videos to see if I can fix this! I am happy to go down to individual component replacement/strip replacement etc - it's all in the name of learning.
The issues are as follows: the... -
I recently replaced the led backlights with LB65041 LED Backlight Strips and after putting it back together the backlights work but there are only colored vertical lines only in the center of the tv. I can see the Netflix logo (jumbled) after a minute or less the screen went dark. When I turned it on again the lines were back. Then I replaced the t-con board but the same vertical lines in the picture. My question is what is my next step? Could it be a source tab bond issue? A buffer board issue? Could I have loosened a connection to the panel when replacing the backlights? Should I replace the...
Comment