thanks tried wirh the hair phone but didt change...i thik i ll try with. something more hot....in the other way i have to trash it...

thanks for the ansswer what temperature i have to use and i have to add flux? because if i buy the t iron i ll buy also the flux or something i need let me know thaks, and i have to do with the tv on or with the tv off?...

yes but not so moist it was in a closet...

Hi guys…I need your help. My cousin ask me to fix her tv. The tv when I went to pick up showed 3 horizontal black line. So I know it was a bad panel issue but I could try to fix with the tape method so I said her I could fix easy. When I come back to home, I turned on the tv and now the tv show vertical line colored….and the problem is that I unplug the ldvs cable, first the right side then the left side I still have the lines. The lines never disappear. When the right side is plug in I don’t have nothing on the screen only this vertical lines, when the right side is unplugged I have picture...

thanks Iotas for your help...i give u news....not good news ahah. i was looking around the pic control and i check the vdd voltage and they dont look good they arent stable. around there there are a lot of diode, ic etc so it was over my understanding...but i didnt see nothing bad...so how last try i put the air gun to 400 celsius and i warmed all the board. i try to turn on and i heard clicking...so i put the motor back, and the motor for 3 second starts,..the problem was i didnt see when i warm the board one of a pin of a igbt dissoldering...so after 5 second the motor was on ,something explode...

Thanks for your support…yes I watch with more focus and I understand tha track is common…so should not be that the problem…the only thing strange I find it s this smd that marked on z871…should bi a diode maybe I don’t know… and it s shorts but it s in the track of a traformer…I think that trasformer give the 3.3 volts for the processor because it s near. So that smd is short because maybe it s in parallel with the trasformer coil…but the strange thing is if I take away from the board…and test it how it s a diode…it give me always OL in both the way…so if it s a diode…should...

Hi I have a vorwerk vk200 it didn’t turn on nothing. I checked the main board…and on the MiP2f2 I have a short on the vdd pin and the cl pin that should be not good… if I remove the ic the short on that pin stay still…. So I checked the mosfet g10t60 and also they are good. I checked the diode schottky d06e60 also their look good at the first but if I put the multimeter on both the anode I have short circuit….that is not a good I think… so I remove one by one the diode and when they are out from the board the anode aren’t in short but in the main board there is still a short on the...