17PW26-4 Odd Failure But Simple Fix

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ReeceyBurger123
    Never Give Up !
    • May 2014
    • 7325
    • Britain

    #1

    17PW26-4 Odd Failure But Simple Fix

    Got this 40" Toshiba Lcd Tv its a 40BV700B which is a rebadged Vestel Tv. The fault was turns on works fine for a min then Lcd fades to white and backlight flickers badly normally about a minuet or 2 after it begins to get warm. I originally suspected we had a failed Lcd Panel as ive seen the particular Panel (LTA400HM07) fail lots of times in weird ways but the Tv stays on wont turn off afterwards, wont respond to remote or buttons meaning the processor has shutdown and turned Tcon off.

    The fault was actually the Psu, the switching section Polly cap on this Psu is C878 (grey box behind main transformer) which is a 23nf 600v type had failed. Physically bulged and measured 0nf on my cap meter. After replacing it with a 23nf 1000v type Tv works fine, been running it for hours. If I had a scope I would have checked the output of this thing but I dont, although I suspect it would be bad. Either way that cap was causing the Tv to do some goofy things.

    Hope this helps anyone who gets a 17PW26 casuing the Tv to act goofy check that Polly cap !
    Last edited by ReeceyBurger123; 01-27-2016, 03:18 PM.
    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

    https://www.facebook.com/Telford-Tel...7894576335359/
  • budm
    Badcaps Legend
    • Feb 2010
    • 40746
    • USA

    #2
    Re: 17PW26-4 Odd Failure But Simple Fix

    Can we see the pictures of the board, both sides?
    Never stop learning
    Basic LCD TV and Monitor troubleshooting guides.
    http://www.badcaps.net/forum/showthr...956#post305956

    Voltage Regulator (LDO) testing:
    http://www.badcaps.net/forum/showthr...999#post300999

    Inverter testing using old CFL:
    http://www.badcaps.net/forum/showthr...er+testing+cfl

    Tear down pictures : Hit the ">" Show Albums and stories" on the left side
    http://s807.photobucket.com/user/budm/library/

    TV Factory reset codes listing:
    http://www.badcaps.net/forum/showthread.php?t=24809

    Comment

    • ReeceyBurger123
      Never Give Up !
      • May 2014
      • 7325
      • Britain

      #3
      Re: 17PW26-4 Odd Failure But Simple Fix

      Doh ! I sealed this one up but, I have another to re-cap tomorrow Bud so will get you images then. I will also replace the polly cap on it too.
      Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

      https://www.facebook.com/Telford-Tel...7894576335359/

      Comment

      • ReeceyBurger123
        Never Give Up !
        • May 2014
        • 7325
        • Britain

        #4
        Re: 17PW26-4 Odd Failure But Simple Fix

        Top side of Pcb. Output caps all changed as well as polly cap.
        Attached Files
        Last edited by ReeceyBurger123; 02-09-2016, 05:38 PM.
        Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

        https://www.facebook.com/Telford-Tel...7894576335359/

        Comment

        • ReeceyBurger123
          Never Give Up !
          • May 2014
          • 7325
          • Britain

          #5
          Re: 17PW26-4 Odd Failure But Simple Fix

          Bottom side of Pcb.
          Attached Files
          Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

          https://www.facebook.com/Telford-Tel...7894576335359/

          Comment

          • ReeceyBurger123
            Never Give Up !
            • May 2014
            • 7325
            • Britain

            #6
            Re: 17PW26-4 Odd Failure But Simple Fix

            Polly cap old vs new 223nj 630v.
            Attached Files
            Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

            https://www.facebook.com/Telford-Tel...7894576335359/

            Comment

            • ReeceyBurger123
              Never Give Up !
              • May 2014
              • 7325
              • Britain

              #7
              Re: 17PW26-4 Odd Failure But Simple Fix

              Another 2 I did a while ago bit better image quality. Both polly caps replaced (not in this image) again as well as output caps apart from that these are good Psu's
              Attached Files
              Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

              https://www.facebook.com/Telford-Tel...7894576335359/

              Comment

              Related Topics

              Collapse

              • Sus256
                HISENSE 65E7KQ PRO - no boot
                by Sus256
                Hi all!

                HISENSE 65E7KQ PRO
                RSAG7.820.13512 - chassis
                MT9618BAATAB - cpu
                RSAG7.820.12059 - power
                HD650Y3U77 - panel
                KLM8G1GETF - emmc

                The TV does not turn on, the standby indicator is on. All voltages are present.
                Emms is dead. Not readable, not detected.
                Replaced emmc.
                But with another dump there is no launch

                Terminal log

                UART
                <
                AC_ON
                RPMB key is not yet programmed

                HASH1_VERSION=0x00000000 64bit
                E-B
                FDE enabled
                layout pattern onebin by SAR7,0...
                06-01-2025, 02:11 AM
              • howardc64
                TCL 55S425 few horizontal lines, potential failure on both side of panel/buffer board
                by howardc64
                All left and right refers to looking from rear of TV (or looking from front with TV upside down)
                • TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
                • Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
                ...
                07-24-2025, 05:17 PM
              • harp
                simple win network with optimization issue
                by harp
                simple win network with optimization issue I like to ask some question about configuring simple room win network. So, there is 2 win computer, android4 device and wifi router not connected to internet. The purpose is storage space and manipulation with large files between any device. 1 pc - 192.168.0.2 (winxp sp2) wired to router port#1 2 pc - 192.168.0.5 (win10, enabled smb1.1) wired to router port#2 3 router - 192.168.0.1 with dhcp for wifi (192.168.0.101...) 4 main tablet - 192.168.0.101 (android4) wified to router wifi port I generally work and control transfer with my tablet via ES3 file...
                06-23-2025, 11:01 AM
              • ctroxtell
                Carrier HK50AA063 display controller common failure help
                by ctroxtell
                I've got a control display for a Carrier chiller that I'm trying to understand what the common failure with these boards are. This is the board in question https://www.supplyhouse.com/Carrier-...arquee-Display all of them seem to develop a failure with the up and down arrow buttons on the right side of the display, the esc and enter keys I've never seen fail. Once these boards are plugged in they run 24/7, you used to have to press extremely hard with the end of the blunt screwdriver and you could still get the arrows to work but now it has completely stopped working. The button...
                02-05-2025, 05:31 PM
              • howardc64
                Vizio E55-F1 dark backlight zones. LED failure or Dimming Zone Driver?
                by howardc64
                Problem

                Fixing a dimming zone TV with LEDs not lighting up. Dimming zone circuit introduces added variable to diagnose LED and/or Dimming Zone Driver board? Some 1/2 rows of LEDs appears to be out in active dimming zone off AND some brightness flickering with active dimming zone high while playing changing video



                Model & Board Pics



                Conflicting Spec

                Vizio indicate this TV has 10 dimming zones. However, LED strips and Zoned light driver connector suggest 12

                https://www.shopjimmy.com/vizio-gj-2k1...
                10-10-2024, 01:16 PM
              • Loading...
              • No more items.
              Working...