Re: Emerson LF501EMF4 Dead
maybe it is just a shorted chip cap on the IR board?
maybe it is just a shorted chip cap on the IR board?
-
-
Re: Emerson LF501EMF4 Dead
Well like mentioned it now has the IR board from the broken screen tv and now I get at least a blinking red light. The original IR board was no light at all no matter what boards were in it.Comment
-
Re: Emerson LF501EMF4 Dead
Utterly fed up with this POS! Received replacement board from SJ and same thing just a blinking red light in front. So just to recap I have 4 power boards 4 main boards 2 sets of cables and no matter what combination I use the best I can get is a blinking red light. I even just made a mock up with just the 2 boards and switch and still blinking red light. The only thing I noticed in this mess is the original IR board would not do anything and the one from the busted screen TV would blink. Could it all be in another bad IR board???Comment
-
Re: Emerson LF501EMF4 Dead
well... I am out of ideas right now.Comment
-
Re: Emerson LF501EMF4 Dead
It was the IR board. Replaced it and works so down the road it goes.vComment
Comment