i have connected standby 3.3V to Pin 29 (Pin 29 is still connected to board, i have not lifted it) and after 2-3 minutes picture freezes and tv itself switching on and off most of the time backlight fails to turn on...
There is no need to lift that pin 29 because you already lift pin 43 (output pin) of the other IC already.
"and after 2-3 minutes picture freezes and tv itself switching on and off most of the time backlight fails to turn on" So the 8-blink codes went away and you are able to get the pictures but the pictures freeze.
I do not think there is much more you can do at this point.
yes 8 blinks error is sorted now i need to work on 10 blinks, tv worked for more than hour and ended up with 10 blinks and then restarting again and again and most of time i can see green light on but no picture...
Hi
another major problem, Backlight don't turn on most of the time, its getting proper voltage, i have checked 24 volts but it turns on after approx 20 attempts
You need to look at the BL-ON (or INVR -ON) to see if the main board if the Main board is sending the ON command signal or not, you also need to look at the Dim or PWM Dim command signal also. It seems to me the main board is failing so all these things are happening.
I have checked almost all resistance on board,
it reads INR-ERR Reads 0.55 volts
Backlight ON reads - 0 volts
Dimmer reads - 0.86 volts
Backlight is coming from ic5502 (MB91F313APMC-GE1) pin 78 and it reads 0 volts on ic, does it means ic is defective or ic is not getting input volts?
what should i do now??
Please suggest.
"Backlight is coming from ic5502 (MB91F313APMC-GE1) pin 78 and it reads 0 volts on ic, does it means ic is defective or IC is not getting input volts?
what should i do now??" It can be that chip is not running or something else causes it to be stuck in that mode. I have no idea how far you can go at this point.
Sorry I have been out for a while, and still recovering (https://www.badcaps.net/forum/showthread.php?t=48410). I do not have the time right now to look back on what we have done to this TV since my last post.
Comment