Hey all!
I probably already know the answer to my question but here it goes anyway.
I got this for the price of a big mac meal, came with the remote and 2 pairs of 3D glasses, the panel comes on and work but the picture looks like a bad V-sync like an old CRT screen, the picture doesn't roll but the black lines/defects do, also the picture is dim and flickers the LEDS are fine when the screen is on black no flicker at all, only when a signal or menu is up or open.
I got into the SM and found the test patterns there was 5 options only 3 were available and none had any information on what was being tested so I assume it was Main board, FRC and T-con. All of them failed.
I have yet to take it a part, its bigger then my work bench so I need to find a safe place to lay it down or prop it up.
Such a bummer if its a bad screen, this was the top of the line Sharp and not very old as the unit only had 3400 hours on it.
Thanks all!
I probably already know the answer to my question but here it goes anyway.
I got this for the price of a big mac meal, came with the remote and 2 pairs of 3D glasses, the panel comes on and work but the picture looks like a bad V-sync like an old CRT screen, the picture doesn't roll but the black lines/defects do, also the picture is dim and flickers the LEDS are fine when the screen is on black no flicker at all, only when a signal or menu is up or open.
I got into the SM and found the test patterns there was 5 options only 3 were available and none had any information on what was being tested so I assume it was Main board, FRC and T-con. All of them failed.
I have yet to take it a part, its bigger then my work bench so I need to find a safe place to lay it down or prop it up.
Such a bummer if its a bad screen, this was the top of the line Sharp and not very old as the unit only had 3400 hours on it.
Thanks all!
Comment