I have a Samsung LN32B360C5D which is working fine via the RF, Component and VGA inputs. The 2 HDMI inputs however, display a blue screen, occasionally a black screen with the input and resolution in the top left corner. The HDMI connectors look quite clean and undamaged under a magnifying glass, and I've ruled out the HDMI cable and the video source. The set does sense an input on HDMI 1 & 2, otherwise they're not selectable via controls, but no picture or sound. Any suggestions would be appreciated.
-
-
Re: Samsung LN32B360C5D no picture/sound on HDMI
maybe try a firmware update, if one is available. -
Re: Samsung LN32B360C5D no picture/sound on HDMI
not clear, are you saying they use to work or not since you've had it?, some tvs have settings where you can block certain inputs with remote etc.Last edited by nomoresonys; 01-21-2015, 09:31 PM.Comment
-
Re: Samsung LN32B360C5D no picture/sound on HDMI
The HDMI's haven't worked since I got this 6 months ago, running component and VGA. found the firmware update, put it on a stick, it didn't find the stick, perhaps wrong format, going to try another stick and go from there.Comment
-
Re: Samsung LN32B360C5D no picture/sound on HDMI
situations may differ, but with my update, it said to format the stick to fat 32, it was already at fat 32, so I didn't format, for some reason it didn't work, so went back and formatted fat 32, even tho it already was, this time it worked, no idea why.Comment
-
Re: Samsung LN32B360C5D no picture/sound on HDMI
Most of my sticks are NTFS so I formatted Fat 32 and this model wouldn't see it, went with FAT, unzipped the files, installed and the HDMI ports started working.Comment
-
Hi, I have a Samsung UE50TU with:
- sound and backlight, but no picture
- when it arrived, it had a picture for a few seconds
- it keeps rebooting
- without ribbon cable between the two panel boards, it does not reboot but I have no picture
- without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
- when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.
- without cable between mainboard and lcd panel and with a jumpered... -
I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.
I ordered a supposedly ‘new' Tcon board this time, and... -
Hi all
I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.
Symptom:
No picture no sound.
When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
No sound at all.
What I tried:
1. I tried unplugging the left or right ribbon... -
Hello all,
This is my first post, but long term lurker on the form learning as much as possible about these TV's. I was given this TV as due to a power outage of constant On/off of power to TV. The TV originally would just click on and off (Typical Reboot Cycle). I opened the back of the TV, and troubleshooted by taking the 96 pin LVDS off one at a time to see if I had a picture on either side. I finally fixed the reboot cycle by finding the error on the left side of the screen off connector CN 1301, and the TV would stay on. Further troubleshooting led me to the driver boards where... -
Hi,
I got Samsung 55 inch QLED QE55Q67RAT where there is no sound at all and when using youtube for example picture is not clear and noisy.
I have swapped Burr-brown 88002A chip on the mainboard but didn't help, different set of speakers didn't help either
Mainboard is based on pcb BN41-02695A BN94-14007B
I will appreciate any help
Many thanks
Marek...
Comment