Lg 50pg20

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • drussell
    Senior Member
    • Nov 2014
    • 144
    • Canada

    #21
    Re: Lg 50pg20

    Originally posted by jose6326
    Before I put everything back together
    Should I test any other voltages?
    I would let the set run for half an hour to stabilize and then touch up the adjustable high voltages like the Vs, Va, VZb, whatever that model has that is adjustable.

    Then you should be good to go!

    Comment

    • sugar_ray
      Senior Member
      • Dec 2012
      • 121
      • Canada

      #22
      Re: Lg 50pg20

      Right on Jose!! Happy ending and you didn't even have to order replacement boards!! Those LVD cables can be tough to seat properly, glad this worked out for you

      Comment

      • rccrasher65
        Badcaps Veteran
        • Mar 2014
        • 619
        • United States

        #23
        Re: Lg 50pg20

        Nice job, congrats!

        Comment

        Related Topics

        Collapse

        • cmlewis89
          LG 47LB5DF blown power supply board
          by cmlewis89
          Hi folks,

          I'm new to this forum. So my trusty 17-year-old LG 47" LCD recently died. As I was booting it up, I heard a hum followed by a loud bang, sounds of pieces flying around, and loss of power to the unit. Inspecting the PSU, I saw two obvious problems: a blown thermistor (bang + flung pieces) and a visibly bulging main cap. Inspecting as many components as I could with my Fluke MM, I diagnosed that the following components on the "hot side" of the board were also bad: one of the 2 main MOSFETs, main 8A fuse, small cap (25V 47uF) connected to main caps, and a blown...
          09-03-2024, 07:50 PM
        • homesync
          Zotac RTX 2070 super.What can i use to replace this blown cap?
          by homesync
          I have a non working Zotac RTX 2070 super. One of its caps is blown. I need help finding out where i can buy this exact capacitor or a suitable replacement for it.

          The diameter is about 5mm...
          10-24-2022, 12:25 PM
        • spiros.p
          replace 100v 100nf ceramic capacitor with 50v 100nf
          by spiros.p
          can i replace 100v 100nf ceramic capacitor with 50v 100nf in an amplifier it will be safe?
          10-19-2021, 08:13 PM
        • drscoot
          HP X360 convertible battery blown fuse error, not charging
          by drscoot
          HP Modelnumber: 14-dh0061nb​
          This laptop had a shorted cap on a Vcore section. After replacement is works again. But there is still a battery issue.
          The battery is HT03XL and with the built-in component test from HP, in the Power section, I get an error: Logic State: Calibration required (20), Charge state: Blown Fuse (42)
          I have another same battery, also with error: Logic State: Very Weak (70), Charge state: Blown Fuse (42)
          And a third battery TF03XL (looks identical) with error: Logic State: OK (0), Charge state: Blown Fuse (42)
          All these 3 batteries are charging...
          12-15-2023, 05:54 AM
        • legg
          LG 42PC3 buffer output doesn't follow YSUS
          by legg
          LG42PC3D -UD originally with green lamp but no display or audio.
          Owner says was working, then went 'pop'.
          All 5V caps bulging. replaced.
          All PSU output voltages within spec but -Vy is low on YSUS.
          One of three parallel fets between SUS_OUT and SUS_DN is zenering,
          eventually shorts DG. Replaced all 3 - -Vy now OK.

          Y scan buffer test point does not follow YSUS output below -50V

          Note: This unit seems to expect YSUS output to park at -Vy in between
          drive signal pattern periods. A replacement drive signal board confirms this....
          11-18-2021, 11:49 AM
        • Loading...
        • No more items.
        Working...