Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • 77slurm77
    Member
    • Jan 2015
    • 10
    • USA

    #1

    Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

    I was given an older Philips 47PFL7422D/37 that was no longer working. The TV turns on, the speakers make the "pop" noise, the blue power LED is solid, the green lights on the mainboard are not blinking erratically or anything but I cannot get a picture to come up at all. Pressing the Menu button does not display anything on the screen. I have found a way to use the Menu button in combination with the channel button to switch inputs and the old yellow, white, and red connection is producing sound but no picture.

    Any ideas?
  • capkid
    Badcaps Legend
    • Oct 2010
    • 1339
    • United States

    #2
    Re: Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

    My guess would be a t-con issue. The t-con fuse blows in some of these Philips LCD TVs. I'd start there.
    Last edited by capkid; 01-15-2015, 11:50 PM.
    LG Plasma Mal-Discharge Correction Service

    Comment

    • kevinjo
      Member
      • Aug 2014
      • 49
      • USA

      #3
      Re: Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

      Believe it or not, I had this TV a few months ago and found a 100uf 16 volt cap worn out. Replaced and everything was fine and is still fine from what the customer says. I have had other Philips with similar issues. So check all 100uf 16v caps and if they test bad..change them. Not sure if it is your issue or not but with Philips..good place to start. This usually happens on the main boards not the power.

      Comment

      • CapLeaker
        Leaking Member
        • Dec 2014
        • 8325
        • Canada

        #4
        Re: Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

        Easy check: Check with and oscilloscope the LVDS signal on the main board. Press the menu button on and off all the time, while you are looking at the scope. IF the LVDS signal changes on the scope, you know the mainboard is fine. Also make sure all the fuses are good on the T-Con board. You can try also heating or cooling your boards, see if that yield a result.
        Last edited by CapLeaker; 01-16-2015, 05:23 AM.

        Comment

        • 77slurm77
          Member
          • Jan 2015
          • 10
          • USA

          #5
          Re: Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

          Thanks for the responses and sorry for the late response. I don't have any tools to test but from what capkid said and seeing a few videos I'm guessing it's the T-Con board. I have ordered a replacement so we shall see. Thanks again everyone! I was about to give up on this thing. I will update the post once the replacement board comes in.

          Comment

          • 77slurm77
            Member
            • Jan 2015
            • 10
            • USA

            #6
            Re: Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

            Originally posted by capkid
            My guess would be a t-con issue. The t-con fuse blows in some of these Philips LCD TVs. I'd start there.
            This was it!!

            I replaced the t-con board and it's working like a champ!

            Thanks everyone!

            Comment

            • CapLeaker
              Leaking Member
              • Dec 2014
              • 8325
              • Canada

              #7
              Re: Philips 47PFL7422D/37 backlight comes on, sound works, no picture.

              Thanks for the feedback!

              Comment

              Related Topics

              Collapse

              • TR103
                Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
                by TR103
                Hi, I have a Samsung UE50TU with:
                - sound and backlight, but no picture
                - when it arrived, it had a picture for a few seconds
                - it keeps rebooting
                - without ribbon cable between the two panel boards, it does not reboot but I have no picture
                - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
                - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

                - without cable between mainboard and lcd panel and with a jumpered...
                01-22-2025, 04:12 PM
              • Mgiffune
                Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
                by Mgiffune
                I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

                I ordered a supposedly ‘new' Tcon board this time, and
                ...
                06-09-2024, 10:28 AM
              • Ierwin
                Samsung UE60KU6079 backlight okay mainboard responsive, no picture, no sound
                by Ierwin
                Hello everyone,
                Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
                The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
                He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
                I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
                Anyway I still fully expect that there has been something seriously damaged...
                05-13-2025, 03:31 PM
              • jchang
                Samsung UN70NU6900F no picture and no sound
                by jchang
                Hi all

                I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.



                Symptom:
                No picture no sound.
                When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
                No sound at all.



                What I tried:
                1. I tried unplugging the left or right ribbon...
                01-09-2023, 06:28 PM
              • aidanmo
                Philips 43PUS7506/12 - Loud blown out sound
                by aidanmo
                Hello,

                I've got a really strange issue with the speakers on my Philips 43PUS7506/12. It makes this awful loud buzzing now. It happened after it was attempted to be wall mounted - I think the back got squeezed and something broke.
                I thought maybe the speakers got damaged, so I replaced them - no dice.
                • Using the internal speakers, it always happens.
                • Using the headphone jack, it never happens.
                • Using the digital/optical out with a soundbar - it happens after about 2h/movie runtime - it's never as drastic, it just pops in and out, but I didn't want it to damage the sound bar
                ...
                02-28-2025, 03:13 PM
              • Loading...
              • No more items.
              Working...