I picked up a philips 42 inch plasma tv the other day, doesn't turn on just on and off. So I unscrewed the back and bam, there's 6 caps bulged and leaking.
Got my new caps today and replaced them, no go still turned on and off.
Checked the fuses on the board and here's the funny thing and my question.
I found a fuse fully blown in half, this guy put a 20a fuse in the t8ah/250v
and the t8ah/250v the t1a250 v spot.
Would this cause the capacitors to blow?
I guess my question is can you put these higher voltage fuses in lower fuses spots? I plan on getting the correct sizes for all of them, but the fuses that were in the board are still doing ok and reading 0.
Got my new caps today and replaced them, no go still turned on and off.
Checked the fuses on the board and here's the funny thing and my question.
I found a fuse fully blown in half, this guy put a 20a fuse in the t8ah/250v
and the t8ah/250v the t1a250 v spot.
Would this cause the capacitors to blow?
I guess my question is can you put these higher voltage fuses in lower fuses spots? I plan on getting the correct sizes for all of them, but the fuses that were in the board are still doing ok and reading 0.
Comment