Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
had the back off, checked and reseated the ribbon cables, just in case, but still the same.
the t-con has a led flashing and is a stable flash,
flash on, then off for a second, then flash on again, is this correct?
ive ordered another t-con anyway, i should have it buy the end of the week
You could rule the T-con in or out by a quick test.
On the 4 pin connector, jumper pins 3 & 4.
Unplug LVDS, when you plug TV in it should jump straight to cycling test patterns.
If test patterns are bad = definitely control board
If they are not = more likely main board than control board
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
got the t-con today and fitted, think its dead, the led flashes the same but tv will not prime or show pic ?
is there somethink i have to do, to marry the t-con to the av board ?
im confused.
ok, found out what the problem is, stupid mistake, all part and pcb numbers match, but turns out it;s for the 42" model, and it has a different chip.
theres a lesson to learn.
The LJ41-xxxxxx number is the board pattern number, the part number is all ways the
LJ92-xxxxx number and the only one to go by to be sure of getting the right board for you set Flocko
Comment