Is there a good way to wire fans to turn on with tv?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • tom66
    EVs Rule
    • Apr 2011
    • 32560
    • UK

    #21
    Re: Is there a good way to wire fans to turn on with tv?

    You can run a 12V fan on 15V. It will run faster. Most of them are rated something like 7~16VDC. You can also use a resistor in series to drop the operating voltage which will be far simpler than a linear regulator.
    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

    Comment

    • davep911
      Member
      • Jul 2014
      • 35
      • US

      #22
      Re: Is there a good way to wire fans to turn on with tv?

      After 2 weeks running 2 thermister fans at about 50% I have decided they are too loud. Fans unmounted are really quiet but when screwed to the large, thin back cover they create noise. With the fans the temp is about 110 deg F. Without them it is about 150 deg and with the back cover and fans off it is about 130 deg.

      I don't have kids or any random people around this tv so is there any reason why I couldn't just keep the back cover off?

      Is 150 deg F ok and I am worrying about nothing?

      Comment

      • tom66
        EVs Rule
        • Apr 2011
        • 32560
        • UK

        #23
        Re: Is there a good way to wire fans to turn on with tv?

        Oddly, running with the cover off can be worse. With no ducting for the air, the TV may run hotter than before. I've noticed this on certain Panasonic plasmas.
        Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
        For service manual, schematic, boardview (board view), datasheet, cad - use our search.

        Comment

        • multimeter
          Badcaps Veteran
          • Jan 2011
          • 739
          • united kingdom

          #24
          Re: Is there a good way to wire fans to turn on with tv?

          Originally posted by tom66
          Oddly, running with the cover off can be worse. With no ducting for the air, the TV may run hotter than before. I've noticed this on certain Panasonic plasmas.
          yeah agreed, seen this issue also,when the tv back is removed, its exposed to ambient temps which are higher than a duct vented fan which obviously has forced cooling, = lower temps.
          fixed so far...376 lg lcd tv's,24 onn tv;s,24 panasonic lcd,16 jvc lcd,12 marshall jcm800 amps,refurb of various disco equipment lighting,old style disco decks ,and a flymo!

          ----------------------------------------------
          please let us know if everything works ok if your tv gets fixed, as it will be and aid for anyone else having the same problem and wishing to fix it.it would save people clogging up this site with topics that are duplicated,and can be found easily using the search function.,and taking up valuable space.enjoy your fixed tv!,hopefully!

          Comment

          • tibimakai
            Badcaps Legend
            • Jan 2012
            • 3680
            • USA

            #25
            Re: Is there a good way to wire fans to turn on with tv?

            You should use, those push in rubber feet for the fan.

            Comment

            • davep911
              Member
              • Jul 2014
              • 35
              • US

              #26
              Re: Is there a good way to wire fans to turn on with tv?

              Originally posted by tom66
              Oddly, running with the cover off can be worse. With no ducting for the air, the TV may run hotter than before. I've noticed this on certain Panasonic plasmas.
              Originally posted by multimeter
              yeah agreed, seen this issue also,when the tv back is removed, its exposed to ambient temps which are higher than a duct vented fan which obviously has forced cooling, = lower temps.
              Right, the tv almost seems to move as much air with the fans off as with them on. I think the reason it's cooler with the cover off is because the tv is near an A/C vent that is on most of the time.

              Originally posted by tibimakai
              You should use, those push in rubber feet for the fan.
              Tried with and without rubber feet and the screws loose and tight but there is not much difference. I think 1 of the fans is a little unbalanced and it is being amplified at a large unsupported area of the back cover.

              Comment

              Related Topics

              Collapse

              • mikey5791
                Tiny Tech ATX480W output power ticking
                by mikey5791
                Hi to all forum members,

                ​​​​​​This psu (Tiny Tech model ATX 480W) had been installed in a very old Windows XP PC but recently i pulled it out as the pc cannot start. To test it, i jumped the green wire and black wire on the 24 pin connector. The psu fan jerk a bit but not spinning. I used my dmm to check dc voltage on output connector wire, the 5v red wire keeps ticking a bit at around dc1v....then drops and ticking again around 1v. It is the same situation with the 12v yellow wire.

                Fyi, i desoldered the secondary side electrolytic cap those over 1000uf...
                02-20-2025, 01:11 AM
              • emil_t
                RTX3090 working fine but fans not spinning
                by emil_t
                Hello guys. I have a problem with a PNY XLR8 GAMING RTX3090 graphics card. The problem is that it displays and works fine, but the fans don't spin at all. The problem occurred when someone else removed the fans in order to clean it and broke one of the fan connectors. He replaced it himself and after that, it wasn't working anymore. I guess he damaged something else in the process. What i have done so far: I found 2 capacitors next to the connector that were in a bad shape, he must have touched them with his tools - they weren't shorted, but i replaced them with similar ones from a similar card....
                04-12-2024, 06:54 AM
              • pajdek
                Lenovo Y700-17ISK turn on and off
                by pajdek
                Hello, i have some issues with my laptop Lenovo Y700-17ISK (motherboard BY511 NM-A541), it started when i turn on the laptop, but the lcd wont turn on, i then connected it via hdmi to tv and screen was ok. So i thought maybe lcd stripe is faulty, i removed the bottom cover, disconnected main battery, reset the cmos by disconnecting battery for 1 min, then slighty move the lcd stripe. Conncted power supply and tuned on my laptop, the lcd turn on, it started to load os, then it turn off, after a second it turn on, then after like 3 seconds turn off again, and so on. Removed power supply, waited...
                09-20-2023, 02:49 AM
              • zaler808
                Macbook Pro 15" Late 2013 A1398 Turn off randomly but after workload it shows black screen with fans spinning
                by zaler808
                Hi guys, this my first post but i want to be brief about it, i recently got a MBP L2013, the problem was that after some use the macbook shutted down randomly, at first i suspected to be the battery, and after connecting it with the charger i noticed that i didn´t shut, but after an hour or so it shutdown, after that i started searching a solution to my problem, but my brother tried to help me to find the problem and it that process to replicate the problem he reproduced a 4k video in multiple tabs and not much time after the macbook shutdown to never power again, what i noticed was that the...
                05-23-2024, 05:17 PM
              • Mulp
                VIZIO M65-C1 Does Not Turn On
                by Mulp
                Hi All,

                I am having an issue with my Vizio M65-C1 where it does not turn on. When I plug it in the stand by light on bottom left of screen turns on (white) then fades away. If I press the power button it turn back on and then fades until it is super dim.

                When I remove cover, there are no illuminated leds on the main board, I've seen others with a red/blue led that turns on.

                I've done some research and what is interesting is my voltages all seem slightly different from other people. For example +5/3.5v is 3.48V when on which is different from others on here....
                01-13-2024, 09:57 PM
              • Loading...
              • No more items.
              Working...