Hello i am looking for firmware i have a 50 inch tv stuck in bootloop Vestel 17mb185 VES500QNDH . I have tried with another 17mb18180e same thing maybe both are bad . Thanks
-
-
-
test LED BLComment
-
The problem withthe tv is mainboard leds are ok need to reset firmwareComment
-
OK fixed the mainboard but the colours are weird . any help ?Comment
-
Type menu 4725 and put the picture here.Comment
-
Hello there. Help with VESTEL tv Daewoo d55dm54uans main 17mb185 The client complained that there was no HDMI video from Tricolor and sonyPS 5 consoles. I was in the service after the update, apparently all the keys were flashed. I looked at the information on the Internet and with the help of a flash drive I was able to get the sony PS 5 to work, I ordered HDCP from the flash drive. And CI+ does not understand where to get the Credentials.bin file And how to sign it correctly? and without it, the tricolor is just a black screen...Comment
-
Hi does anyone have the firmware for a Panasonic 50lx650 main board 17mb185
Screen ves500qnzh-n2-z01
23798312Comment
-
Hi all,
I’m looking for a USB firmware file or EEPROM dump for a Hitachi 42HXT12U TV.
The mainboard is a Vestel 17MB95M, and the screen panel is VES420UNDL.
I recently replaced the mainboard with another 17MB95M, but it’s programmed for an LC420DUJ panel, and I’m getting no picture. I’d like to flash the correct firmware via USB or update the EEPROM if needed.
If anyone can provide:- A working USB firmware file (like upgrade_loader.pkg or mb95_m.bin)
- Or a compatible EEPROM dump
07-23-2025, 12:15 PM -
Chiedo aiuto per problema a TV Hitachi 32HE4500 che non si accende più,ho bisogno del firmware della scheda madre vestel 17MB211S codice pannello VES315UNVL-2D-N11 ?
spero che qualcuno può averlo per riprogrammare eprom. grazie
Post in English !!!
I ask for help with a problem with a Hitachi 32HE4500 TV that no longer turns on, do I need the firmware for the Vestel 17MB211S motherboard, panel code VES315UNVL-2D-N11? I hope someone can have it to reprogram eprom. Thank you
-
Hello, i have an old Toshiba 32W1333DN (sorry, misspelled the headline) TV that had the standby led green/red flashing and no lightup problem, i repaired it by measure the led output as suspect led problem, i measured the LED:s one by one and found one bad led, i replaced the the led-straps and the TV works.
Now i need to update the software because the new rc "RM-L890" does not work and i think maybe it could be an firmware issue?, i have struggled to find it without any success because all of the links where invalid, i contacted Toshiba but they do not support this model... -
Hi,
Got a Finlux 65-FUC-8060 TV that doesn't turn on, 5V standby present from PSU, 3.3V on mainboard present, button signal gets pulled low when pressed, but mainboard never sends signal to PSU to turn main rails on.
I suspect corrupt firmware but I haven't been able to find anything for this TV.
TV model: Finlux 65-FUC-8060
Mainboard: Vestel 17MB130S 23473048
Panel: VES650QNTS-2D-U11
At the very least looking for a firmware that can make it turn on to confirm the problem, and hopefully a firmware that's compatible with the panel. -
After an update it stopped playing audio and video, I have reset it as it says in the manual and tried to reinstall the firmware over the internet but logging failed each time and I tried to download the firmware to install it by usb but it does not appear on the official page, could you help me? Since it would be a shame to have to get rid of him, European version Thank you very much
Best regards.
Anyone got their hands on firmware for Marantz SR5008 stuck in update loop
Comment