TV is completely dead.There is 320 volts across main smoother cap but no voltages on the secondary of the power supply.I have seen a couple of people offering a repair service for the board on fleabay for this fault.Does anyone know what the repair is? Searching on the net it seems to be a common problem after switching off from the mains.
-
Last edited by blib; 01-26-2014, 09:57 AM. -
Re: Panasonic TX-P50X50B
Usually fuse + two FETs + driver IC..Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search. -
Re: Panasonic TX-P50X50B
The mains input fuse is OK.Is there another one? Some people are saying that if the set is left unplugged for a while it sometimes will work again.Last edited by blib; 01-26-2014, 10:01 AM.Comment
-
Re: Panasonic TX-P50X50B
Any standby voltage from PSU?Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.Comment
-
Re: Panasonic TX-P50X50B
no standbyComment
-
Re: Panasonic TX-P50X50B
Picture of PSU?
I have a dead 42" X50B PSU here, too. No standby light. Got it from a cracked panel so no idea if external damage did it in, or the guy smashed the screen in frustration.Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.Comment
Comment