Funai LC320EM2

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Ltank
    Badcaps Veteran
    • Jun 2013
    • 776
    • USA
    #1

    Funai LC320EM2

    The set was dead. F601 125v 4 amp fuse blown. Q600 a K10A500 mosfet was shorted. in the primary circuit. I tried to cross reference to no avail.
    could not find a data sheet to get specd to cross it the hard way. Does anyone know general purpose replacement? Could not get the correct service manual either. Anyone? Thanks!
    Tags: None
    • philliesfan30m
      Badcaps Veteran
      • Aug 2013
      • 542
      • USA
      #2
      Re: Funai LC320EM2

      https://www.badcaps.net/forum/showth...t=25477&page=5
      it is k10a50d not 500 try tk10a50d to find it at digikey or mouse or ebay

        Comment

        • freakaftr8
          Badcaps Legend
          • Oct 2012
          • 3743
          • USA
          #3
          Re: Funai LC320EM2

          Check zener diodes in the hot section as well. Most likely shorted one or two.
          Did I leave the soldering iron on?

            Comment

            Previous template Next

            Related Topics

            Collapse
            • csmith
              Funai LC3200SSx Shutting Down
              by csmith
              This set won't power up with alternating green and red power light.
              Forced chassis on all voltages are correct except all 6V. It measures 28v.
              on cathode of D661. Anode measures 6v. Mainboard is BA94F0102 4_a.
              Schematic I'm using LC320MEM9 which is not close enough. Any suggestions
              from the Funai experts. Thanks!
              01-25-2023, 03:39 PM
            • connorcc2005
              Thermistor specs and cross reference
              by connorcc2005
              Hi,

              I'm getting some conflicting information and thought I'd toss it out to all of you for input.
              What I have is a TTC-104 thermistor. This is part of a temp sense circuit that will drive a small 12v fan to cool components mounted to SMPS heat sink.
              The physical diameter of the piece is 5.1mm measured with a caliper.
              Other than what you see in the pic, there is no other writing on the part.

              My research of the TTC-104 says it should read 100 ohms at 25C. Out of circuit measurements have it at approximately 100k. It does change as the temp changes....
              06-16-2022, 04:16 PM
            • raregtp
              Voltage regulator cross-reference
              by raregtp
              Hey all....hoping someone can help me with this. I have a couple voltage regulators I'm trying to cross but not having much luck.

              The first is:

              A1
              AS1117L-18
              B0640 25

              The second is:

              A1
              AS1117L-33
              B0640 28

              I know the AS stands for Alpha Semiconductor, and I think I've found a datasheet for the AS1117L-33, just can't find anything for the -18. Ultimately I'm looking to cross these over to parts that I can get now, as all I'm finding similar are AZ1117 regulators.

              If anyone can assist...
              03-15-2020, 11:12 PM
            • JDC
              (SOLVED) - Funai FW55D25F - High Pitched Squeal Upon Power-on.
              by JDC
              Issue: Funai FW55D25F - High Pitched Squeal Upon Power-on.

              Solution: Replace C3208 and C3209 on main board. These are surface mounted capacitors. Values unknown so I just used same physical size capacitors from a donor board.
              02-01-2022, 10:25 AM
            • Michale32086
              FUNAI/SANYO FW55D25F Shuts Down Randomly
              by Michale32086
              I have Sanyo 55" TV that randomly shuts off..

              Sometimes it will stay on for 5mins or so, sometimes it shuts off after a min or two...

              When it DOES stay on, it works fine...

              All things being equal, would it be more likely a POWER Board issue or a MAIN Board issue???

              Thanx in advance......
              07-12-2022, 12:41 PM
            • Loading...
            • No more items.
            Working...