Vizio E3D470VX Logo Stuck on Screen

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • barryra
    Senior Member
    • Aug 2013
    • 107
    • USA
    #1

    Vizio E3D470VX Logo Stuck on Screen

    I have a few questions in my Vizio E3D470VX... I turn on.. & the V logo shows & I cannot do anything else. If I press buttons.. Nothing just the V logo.

    I am hoping it's not the main board but rather some type if update. What do you think it may be? Thank you
    Tags: None
    • Caleb
      Smokin IC's
      • Feb 2013
      • 645
      • USA
      #2
      Re: Vizio E3D470VX Logo Stuck on Screen

      Sounds like corrupted eeprom.....on the main board, but you should check the voltage regulators for good measure. See this thread for the low down
      Liberating magic smoke one part at a time

        Comment

        • barryra
          Senior Member
          • Aug 2013
          • 107
          • USA
          #3
          Re: Vizio E3D470VX Logo Stuck on Screen

          Caleb.. Thank you for the response. Wouldn't the board need to be replaced if it was a bad eeprom? Since they are programmed to a specific tv?

            Comment

            Previous template Next

            Related Topics

            Collapse
            • Stunt
              Hp Laptop Stuck on Hp protected by hp sure start screen
              by Stunt
              Hi guys i've got an Hp laptop Zbook 17 g5 Stuck on Hp protected by hp sure start screen.
              I have tried almost every bios available on various platforms about this laptop but the problem is still the same.
              I even successfully build my own bios using the one from the Hp website but the problem the laptop still getting stuck there.
              Even if i try to press Esc key nothing happens. I tried f10 it doesn't go to bios still stuck there i just saw entering setup menu on the bottom left corner of the
              screen that's it and stuck there. I left it until the following day and i still...
              09-02-2025, 01:51 PM
            • spice_disc
              Vizio TV M50-C1 reboot cycle and static on screen
              by spice_disc
              I'm currently trying to diagnose and fix my Vizio TV (Model M50-C1). I've tried a number of different basic solutions, but I'm trying to determine if my issue is currently a failing panel, T-Con board, or main board (or something else entirely) and whether or not it is worth my time to fix it. Details of the issue and what I've tried are below as well as why I think it is either a bad panel, T-Con board, or main board.

              The Issue: The TV will be on and working fine but after the TV is on for ~5-10 minutes the screen will freeze (with sound continuing) until the TV reboots itself. While...
              1 Photo
              09-08-2024, 02:37 PM
            • paulxxxx
              Vizio E701i-A3 stuck at logo, need service manual
              by paulxxxx
              The TV stuck at logo and cannot be turned off unless the cord is unplugged.
              I was given two main boards and exactly the the same thing happens to both of them.
              I have checked all voltages on the connector on the power board that goes into the main board and they all look OK.
              There are no signs of damage on any of the 3 boards.

              Would someone help me with a pointer to the manual? It's supposedly to be the same as E601i-A3.

              Thanks!
              09-08-2023, 01:11 PM
            • abajor
              A2141 Screen replacement. Boots screen freezes on Apple Logo 1/3 status bar unless connected to second monitor.
              by abajor
              Having this very weird issue.
              The owner of this laptop complained about screen being intermittent when opening and closing, and has been using the laptop on a thunderbolt video connection since the screen failed.

              I swapped with a working screen from an A2141 waiting for parts.

              The Os exhibits this weird behavior where it boots to to 1/3 the status bar, then it makes the boop sound. It's at the log in but for whatever reason the desktop isn't loaded.

              The laptop boots fine into recovery mode. I updated from Monterey to Sonoma and the laptop still has...
              04-27-2024, 01:37 PM
            • reformatt
              Macbook Air M2 A2681 Kernel panics after screen replacement
              by reformatt
              Just had a customer bring in a M2 MBA A2681 that had had a screen replacement in April at another repairer. Since then, she has been getting intermittent kernel panics. It's an aftermarket screen, and of course it fails in diagnostics as the calibration hasn't been done. The error in the panic log is "No device added after powering on the rails".

              It seems the original repairer has swapped the board and the screen to other MAC's, and said that it isn't a screen issue. From what I understand, by doing a quick search on Google, this is in fact a screen issue. The panic relates...
              07-31-2025, 08:37 PM
            • Loading...
            • No more items.
            Working...