Vizio Va370M IR sensor problems
I everyone, I'm new here so I will apologize in advance for any mistakes I make in proper etiquette. I have a Vizio Va370m that I picked up for cheap. The man told me there were problems with the picture after warm up but after 10 hours of running I could not simulate it.
The only problem I have is the ir sensor won't pick up the remote. I checked the remote on another vizio and it works fine. I checked for any noticeable bad caps & didn't see any. I went ahead and ordered a new ir sensor board thinking that was the problem. Installed it today.... and nothing. So I started checking voltages(I know, should have done that first), there is a 13 & 12 pin connector on the power supply. Everything seems close. The 24's are 24.1, the 12's are 11.8-9, and the 5.0 is 4.7. The voltage at the ir sensor is 3.3.
Thanks, DSneller
The only problem I have is the ir sensor won't pick up the remote. I checked the remote on another vizio and it works fine. I checked for any noticeable bad caps & didn't see any. I went ahead and ordered a new ir sensor board thinking that was the problem. Installed it today.... and nothing. So I started checking voltages(I know, should have done that first), there is a 13 & 12 pin connector on the power supply. Everything seems close. The 24's are 24.1, the 12's are 11.8-9, and the 5.0 is 4.7. The voltage at the ir sensor is 3.3.
Thanks, DSneller
Comment