Model kdl-46hx800 tv just over a year old has two vertical bars on the right half of the screen. The left bar flickers and changes from light gray to black. Sometimes is has a blue thin dotted line running down the side of the bar also. The bars are there from the moment the tv is powered on and do not go away. Also, sometimes the right half has flickering bars, everywhere, but they don't stay. See picture. it is sideways for whatever reason...
Sony Bravia LCD Vertical Lines
Collapse
X
-
Re: Sony Bravia LCD Vertical Lines
Model kdl-46hx800 tv just over a year old has two vertical bars on the right half of the screen. The left bar flickers and changes from light gray to black. Sometimes is has a blue thin dotted line running down the side of the bar also. The bars are there from the moment the tv is powered on and do not go away. Also, sometimes the right half has flickering bars, everywhere, but they don't stay. See picture. it is sideways for whatever reason...
PlainBillFor a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.
Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic. -
For a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.
Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.Comment
-
Re: Sony Bravia LCD Vertical Lines
Had a problem like that on Toshiba, took it apart down to the LCD panel it self, there some small ribbons that go from the board to the panel. I took a hot air resoldering unit and went over the connections on the panel and it fixed the problem. I covered the panel with a small peace of metal so it wouldn't damage the screen it self. Might give that a try.Comment
Related Topics
Collapse
-
First. it has no picture at all. i solved it by covering the ckv lines using tape to to block the connections
Second. now has picture but with vertical lines that follow the image. tcon board ic overheating
tried blocking LC lines too, but same results
is it lcd panel issue or tcon board issue?... -
by gpo23Hello,
i order a t-con because i had bad colors on my SONY KDL-40V3000 :
With the new t-con the color are good but there are vertical lines on all the screen :
I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)
Is there a way to fix the vertical lines on the new t-con ?
Thank you for your help
gpo23... -
by Stanley1843Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
-
Channel: Troubleshooting Computer Displays
-
-
by thstuffThis "free from a friend who was going to recycle it" SONY BRAVIA XBR-55A8H arrived with the bottom center RED LED repeating a four flash pattern. It was treated with kid gloves and was reported to have "just gone dead" and the OLED panel has no dents in the metal frame or cracks.
Thread https://www.badcaps.net/forum/showthread.php?p=1091829 helped in proceeding as follows:
1) Unplugged, then plugged set in while holding the remote VOL- and Power to factory reset.
2) Waited 30 seconds, then pressed remote Power button and "Select language"...01-30-2023, 05:01 PM -
by dustman1747I have acquired a Sony XBR-65X900H to try and fix. It probably was a complete no power situation. The main board was replaced and the TV started turning on. I now have start sounds and backlights, but no image. I've replaced the t-con with no improvement. Cables all appear to be ok and seated properly. The TV took a firmware update and hard reset but neither helped.
Using the tape trick I can get both side to display combinations of colored vertical lines. There is no change in the stripes and the pattern always appears the same. If I add additional tape strips I can get the screen... - Loading...
- No more items.
Comment