Sanyo lcd-37xr9da picture negative, abnormal display

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • pigdaddy
    New Member
    • Oct 2011
    • 5

    #21
    Re: Sanyo lcd-37xr9da picture negative, abnormal display

    Hi mate. just heard back and for me it was a faulty tcon. haven't viewed the unit yet. just got the call. hope this helps in some way, apparently the part was about $150 from Sanyo. maybe u can source a new unit from them?

    Comment

    • tw2005
      Badcaps Legend
      • Oct 2011
      • 6458
      • Australia

      #22
      Re: Sanyo lcd-37xr9da picture negative, abnormal display

      Cheers, Thanks. That's what I heard too so at least their pricing is consistent(Sydney).

      what I ended up with was viewable. I've just offloaded it but it appears to me this is what goes on these sets and around the 2 year mark.

      I'm just glad my diagnosis was correct, good learning experience.

      Thanks.

      Comment

      • Tech Pal
        New Member
        • Dec 2011
        • 1

        #23
        Re: Sanyo lcd-37xr9da picture negative, abnormal display

        i have the same problem too with my Sanyo LCD 37xr9da and im hoping that i can fix it.

        Comment

        Related Topics

        Collapse

        • Fly_Among_Stars
          VIZIO E70-E3 Half picture with half TCON
          by Fly_Among_Stars
          Hi,
          I have a VIZIO E70-E3.
          Symptoms: Black screen, no picture, but LED backlights are working.
          I probed the power board and voltages are as listed on the board.
          Main board appears fine, too.
          I believe the problem is either a bad T-CON board, or connection to LCD, or bad LCD.
          There are two separate ribbon cables feeding the LCD.
          If both are connected, the screen is black.

          If only the ribbon cable that feeds the right side of the screen (when viewed from the front) is disconnected, the left side of the screen shows picture and...
          04-24-2023, 08:20 PM
        • shelby5041
          Samsung LCD TV no picture backlight on no 12v at tcon
          by shelby5041
          hi
          i have a samsung lcd tv

          it powers on with sound and backlight but no picture

          all voltages from PS are good 12v 3.3v and 5v

          whats odd is that at the tcon i tested voltage across the fuse on the tcon and i get 0v

          i figured main board issue..so i ordered a used main board....when i put replacement main board in i still have same issue

          no 12v at the tcon fuse

          i disconnect the panel ribbon cables to rule out any panel issues and i still have no 12v at the tcon fuse

          the odds of having 2...
          10-08-2021, 08:21 AM
        • x_orange90_x
          TCL 50S535 bad tcon or panel issue?
          by x_orange90_x
          Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
          03-29-2025, 11:02 PM
        • Tr0ll
          T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
          by Tr0ll
          Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

          The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

          Original T-con:
          Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

          First replacement T-con:

          I thought it might be t-con and ordered new t-con from china(supposedly tested)...
          10-07-2023, 07:48 PM
        • JJAAMM
          SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
          by JJAAMM
          This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

          Problem
          TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
          07-06-2023, 06:01 AM
        • Loading...
        • No more items.
        Working...