MFC Brother l3750cdw photocopier stays frozen while receiving data.!! please help

valente222

Senior Member

Join Date: Feb 2021

Posts: 80

Country: PERU
#1

MFC Brother l3750cdw photocopier stays frozen while receiving data.!! please help

06-03-2023, 05:55 PM

Hi guys, I have a problem with this copier, Brother MFC-L3750CDW. It seems to have a defect in the firmware because it is blocked when sending documents over the network or USB connection. Is it possible to physically flash? Its main problem is that no cable connection works. This printer is only working from the front panel for scanning.
Tags: None
djazeiry

Member

Join Date: Sep 2023

Posts: 15

Country: algeria
#2

10-03-2023, 04:10 PM

Re: MFC Brother l3750cdw photocopier stays frozen while receiving data.!! please help

dude i guess it needs to be flashed by a special tool , the chip need to be removed from it's motherboard and prgrammed
Comment

Previous template Next

Brother J2730-DW stuck on Brother Logo

by Raymond red (mon)

hello, I have this Brother J2730-DW printer that was brought to me by a friend, it was supposed to be converted to continues ink but the printer wouldn't turn on completely. The printer powers on and plays a tune but it gets stuck in the brother logo. Upon checking, the printer was infested by many small cockroaches. I do checked the board cleaned and tested some corroded capacitors but all seems to be fine, I couldn't find any short circuit or any missing component on the board. Also checked the power supply and it was working fine.
please help.
- Channel: Troubleshooting Printers, Copiers, Scanners and other Imaging & Printing Devices
11-08-2024, 09:19 AM
BROTHER MFC-J5340DW dump

by smile

Looking for BROTHER MFC-J5340DW BIOS and memory.

What programmer do I need to read these Brother chip, RT809H?
- Channel: Troubleshooting Printers, Copiers, Scanners and other Imaging & Printing Devices
12-27-2024, 08:21 AM
Brother DCP-L2500D - completely dead

by spleenharvester

Hi everyone

I have quite a bit of experience with low voltage circuits but basically none with high voltage circuits outside of recapping. So if anyone could point me in the right direction I would appreciate it very much!

This printer, history unknown, has no signs of life when plugged into 240VAC. It has the LT2988-001 board common to many Brother HL-2XXX series printers. The only physical abnormality observed is a green tint to the positive leg on the main 400V filter capacitor. This model is prone to shorts across the four Schottky diodes but all are testing OK by...
- Channel: Troubleshooting Printers, Copiers, Scanners and other Imaging & Printing Devices
03-01-2025, 08:58 AM
Brother Maintenance Tools and repair help for QL-570

by DriversScrew

Anyone can provide the software tools for Brother P-Touch QL-570?
According to the service manual there should exist

On the brother homepage I only can find autopoff.exe and a tool called ptsweep.exe.

I got the QL-570 as defective, but it powered up normal (voltages measured ok) with cutting and paper feed working until a paper roll and driver were installed on the connected pc.
The device now only shows a dim red LED light. Powering on/off doesn't work.

I'll do voltage measurements again to exclude an electrical/power supply problem....
- Channel: Troubleshooting Printers, Copiers, Scanners and other Imaging & Printing Devices
06-22-2023, 02:48 AM
LG 75UH8500 color static frozen

by EazyBone

Got a LG with color static frozen. Doesn't move just stays on this picture. I'd assume it's main board but I'm sure one of you has seen this before. Any data helps thanks...
- Channel: Troubleshooting TVs and Video Sources
06-10-2024, 09:35 AM
Loading...
No more items.

MFC Brother l3750cdw photocopier stays frozen while receiving data.!! please help

MFC Brother l3750cdw photocopier stays frozen while receiving data.!! please help

Comment

Related Topics