bad capacitor

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • davidvincent
    David Vincent
    • Jan 2014
    • 24
    • England

    #1

    bad capacitor

    Hi I am new to posting on here my name is David from Wigan Lancashire in England.

    I am trying to fix a psu on a Baird x37dtv I have replaced the start up caps as they were bulging so now the tv will switch on so a victory there.

    The screen now flashes on and off, using info from one of the members on here I have been testing the big Cap 150uf 400v when warmed up with a hair dryer the tv works perfect except for a slight hum on sound.
    My question is should the big cap hold the 400v for quite a while after switch off as I have tested the voltage while working and its just over 400 volts once warmed up, before using the hairdryer its only getting to 332 volts, 10 mins after switch off and its showing no voltage is this capacitor buggered shouldn't it still be charged up

    Thanks in advance for any advice

    DV
    Last edited by davidvincent; 09-18-2014, 05:07 AM.
  • davidvincent
    David Vincent
    • Jan 2014
    • 24
    • England

    #2
    Re: bad capacitor

    I have isolated the capacitor by cutting pieces of plastic and surrounded the cap so the heat goes on to the cap and not surrounding components and the tv starts to work after 30 seconds with the hairdryer I think it is defo this cap so I will order a new one

    DV

    Comment

    • ReeceyBurger123
      Never Give Up !
      • May 2014
      • 7325
      • Britain

      #3
      Re: bad capacitor

      Ok it sounds like the pfc is failing what psu is in the tv (model number) and does the cap look physically failed ?
      Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

      https://www.facebook.com/Telford-Tel...7894576335359/

      Comment

      • davidvincent
        David Vincent
        • Jan 2014
        • 24
        • England

        #4
        Re: bad capacitor

        Hi thanks for your response

        the cap looks fine, the psu is AD301M24-4N1

        There is a thread on here were he had the same fault and heated the cap up and it worked he replaced the cap and it was the same, now like I posted I used some plastic and surrounded the cap and heated it up and bingo I had it on for 2 hours then switch it off for 5 mins and to get it back on you have to heat it up again

        regards

        David

        Comment

        • ReeceyBurger123
          Never Give Up !
          • May 2014
          • 7325
          • Britain

          #5
          Re: bad capacitor

          Try replacing the cap with a higher value like 180uf 400-450v.
          Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

          https://www.facebook.com/Telford-Tel...7894576335359/

          Comment

          • davidvincent
            David Vincent
            • Jan 2014
            • 24
            • England

            #6
            Re: bad capacitor

            Would this make any difference

            Comment

            • SteveNielsen
              Retired Tech
              • Jun 2012
              • 2327
              • USA

              #7
              Re: bad capacitor

              What adjascent components may be heating up during the test?

              Comment

              • davidvincent
                David Vincent
                • Jan 2014
                • 24
                • England

                #8
                Re: bad capacitor

                I will upload a picture

                Comment

                • davidvincent
                  David Vincent
                  • Jan 2014
                  • 24
                  • England

                  #9
                  Re: bad capacitor

                  You can see the components near the Cap from this photo
                  Attached Files

                  Comment

                  • ReeceyBurger123
                    Never Give Up !
                    • May 2014
                    • 7325
                    • Britain

                    #10
                    Re: bad capacitor

                    Originally posted by davidvincent
                    Would this make any difference
                    I usally replace 150uf with 180uf on sets that are worth something it basically gives cleaner voltage to the switchers.
                    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                    https://www.facebook.com/Telford-Tel...7894576335359/

                    Comment

                    • ReeceyBurger123
                      Never Give Up !
                      • May 2014
                      • 7325
                      • Britain

                      #11
                      Re: bad capacitor

                      I dont think its the cap what voltage does the cap measure when the set is on ?
                      Last edited by ReeceyBurger123; 09-18-2014, 01:35 PM.
                      Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                      https://www.facebook.com/Telford-Tel...7894576335359/

                      Comment

                      • davidvincent
                        David Vincent
                        • Jan 2014
                        • 24
                        • England

                        #12
                        Re: bad capacitor

                        around 330 -340 volts at my latest test

                        Comment

                        • davidvincent
                          David Vincent
                          • Jan 2014
                          • 24
                          • England

                          #13
                          Re: bad capacitor

                          the cap goes down to nothing within a few mins when not plugged in

                          Comment

                          • davidvincent
                            David Vincent
                            • Jan 2014
                            • 24
                            • England

                            #14
                            Re: bad capacitor

                            I just done another test on the cap
                            Cold no power ie not plugged in 0 volts
                            Plugged in not switched on 350 volts
                            Turned on screen flashing 340 volts
                            Use hairdryer on Cap until screen stops flashing (steady backlight) 325 volts
                            Last edited by davidvincent; 09-18-2014, 01:55 PM.

                            Comment

                            • ReeceyBurger123
                              Never Give Up !
                              • May 2014
                              • 7325
                              • Britain

                              #15
                              Re: bad capacitor

                              Interesting, sounds like something els but replace the cap first to rule that out.
                              Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                              https://www.facebook.com/Telford-Tel...7894576335359/

                              Comment

                              • davidvincent
                                David Vincent
                                • Jan 2014
                                • 24
                                • England

                                #16
                                Re: bad capacitor

                                ok I will get back once I have the replacement I will order one off ebay

                                thanks for your help

                                DV

                                Comment

                                • ReeceyBurger123
                                  Never Give Up !
                                  • May 2014
                                  • 7325
                                  • Britain

                                  #17
                                  Re: bad capacitor

                                  Originally posted by davidvincent
                                  ok I will get back once I have the replacement I will order one off ebay

                                  thanks for your help

                                  DV
                                  Your welcome, keep us updated
                                  Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                                  https://www.facebook.com/Telford-Tel...7894576335359/

                                  Comment

                                  • davidvincent
                                    David Vincent
                                    • Jan 2014
                                    • 24
                                    • England

                                    #18
                                    Re: bad capacitor

                                    Hi after looking at it again and taking into account all that you guys have said I am now of the belief that the 400v cap is not at fault.

                                    I have really isolated the 400v well using cardboard and plastic and blew warm air above it and the tv started to work, so above it is a diode (that is ok) and a ceramic cap so I put a tube on the ceramic cap and blew warm air the tv did not change.

                                    So above the Ceramic cap there is another diode that seems ok. two small transistor's 1 big transistor TIP31C and 4 very suspect small electrolytic caps 3 @ 47uf 25v and 1 @100uf 25v I have put a tube over the caps I seem to get a reaction from the 100uf cap when I blow warm air on it I am now waiting for the tv to cool down and repeat the tests a few more times

                                    BTW the electrolytic caps are samxon which are known to be pretty bad caps

                                    At last I maybe getting somewhere

                                    I will post again later with results

                                    DV
                                    Last edited by davidvincent; 09-19-2014, 05:46 AM.

                                    Comment

                                    • kc8adu
                                      Super Moderator
                                      • Nov 2003
                                      • 8829
                                      • U.S.A!

                                      #19
                                      Re: bad capacitor

                                      just shotgun all those samxons.
                                      that series/color are known bad.
                                      nice to track it down to a single troublemaker but in the long term those all need replacement.

                                      Comment

                                      • davidvincent
                                        David Vincent
                                        • Jan 2014
                                        • 24
                                        • England

                                        #20
                                        Re: bad capacitor

                                        Yes Agreed the low voltage side is full of them I changed 2 of the samxon start up caps they had blown their tops well on their way anyway.

                                        I am going to change out the 100uf first and if I get the tv working ok I will give the option to my friend (its his tv) to do a full cap change to rubycon caps

                                        Comment

                                        Related Topics

                                        Collapse

                                        • Document Archive
                                          Acer Switch Switch V 10 SW5-017P Hybrid (2-in-1) V 10 Specification for Upgrade or Repair
                                          by Document Archive
                                          This specification for the Acer Switch Switch V 10 SW5-017P Hybrid (2-in-1) can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Switch V 10 SW5-017P boardview and Switch V 10 SW5-017P schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification,...
                                          09-06-2024, 05:30 AM
                                        • Natob82
                                          Micro Momentary Push Switch?
                                          by Natob82
                                          Great to be here! I'm a newbie here trying to find a "micro", momentary push switch to repair a Sony "clamshell" video walkman. This micro switch has long since discontinued by Sony, however I hope there are third-party switches of the same size and functionality that I might be able to source to play the same role. The purpose of this switch is to tell the video walkman that the user has activated the mechanical tape eject button, turning that physical action into an electronic signal that tells the tape transport mechanism to open so one can load or eject a video tape. I...
                                          12-21-2022, 05:22 AM
                                        • grimacelord
                                          NEC TurboExpress On/Off Power Switch Replacement Help
                                          by grimacelord
                                          Hello,

                                          I've been working on a NEC TurboExpress and I accidentally got the plastic inside the power ON/OFF switch too hot while doing other repairs and melted it. At first, it would still power on when sliding the switch, but you had to really press inward while sliding to get it to work.

                                          I removed the switch component and tried to gently melt the plastic back so it would work more reliably and all I managed to do was make it worse.

                                          I need to find a replacement On/OFF switch for this, but having some trouble figuring out which kind of switch I need....
                                          11-09-2023, 09:49 AM
                                        • SluggerB
                                          Help making a switch work the opposite way with a relay
                                          by SluggerB
                                          I have a very small float switch, I'm using in a very small tank. It only fits in one way. Link https://www.amazon.com/uxcell-Switch.../dp/B07DZ1J2GB

                                          I want the switch to be open when the water is high, and closed when the water is low. Unfortunately it works the opposite. And since this switch is designed to be underwater, it's all sealed up, there is no taking it apart or hacking it up.

                                          It will be driving a water pump, basic idea, when the water is low, switch closes, which turns on water pump, when enough water is in the tank, float switch floats,...
                                          02-07-2025, 07:57 PM
                                        • Prolog
                                          RTX 3080 FE Identifying capacitor
                                          by Prolog
                                          Hi people, I hope this is the correct spot to post this, I'm new to the forum.

                                          I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.

                                          I hope these photos make it clear which component I am referring to:
                                          (yes, the soldering is a bit botched from removing the blown one, I know)

                                          I have found the board schematic (attached), but there does not seem to be a boardview available. I have never...
                                          12-01-2024, 08:27 PM
                                        • Loading...
                                        • No more items.
                                        Working...