I need bios. board id: da0u8amb6a0 rev a
-
-
Re: Hp 15-f272 dump
Here is a working dump -
Re: Hp 15-f272 dump
Hello,
Has anyone been able to locate the EC file?Comment
-
Re: Hp 15-f272 dump
Plz help me ecComment
-
Re: Hp 15-f272 dump
Old have ene dump? send old ENE dump.Comment
-
Re: Hp 15-f272 dump
try this .Comment
-
Re: Hp 15-f272 dump
[QUOTE=imranromi;773349]try this .[/QUOTE
thank you my brother. but after the flash I always have the same problem. the machine turns on and restarts 5s after
and then the processor does not heat up even the hard drive does not turn the drive does not start
Please any helpLast edited by Pascal Komlassan; 09-27-2017, 08:57 AM.Comment
-
Re: Hp 15-f272 dump
Cпасибо БРО !Comment
-
Hi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
... -
MSI Alpha 15 B5EEK-237XRU SN:K2209N0193161
Came without initialization. Before that, it was not under repair. With BIOS from the official website, there is a start Ok, after a while the fans gain speed and the laptop turns off.
The cooling system is cleaned, the contact spot is good.
I need a working dump from laptop to check.
This is an original, not working dump....03-10-2024, 07:26 PM -
Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic... -
Hello friends, I've got a nice toy to play with - it is an HP RP7800 All-in-one POS system. I got it for free and it has one problem - it turns on very rarely, and just for a few seconds. After that it dies and doesn't come on if I don't leave it unplugged for at least 2 hours. I've repaired motherboards before, this is not my first one, but problem with these types of faults is that everything you check on the board will usually be fine. This is the case for me here.
I dissassembled it completely, and got my hands on the motherboard. Model No. is PIQ67H/Higgins 11047-I 48.3GD02.011....
Comment