Dell 8FC8 Patcher

[0ldtime]

Thank you, for the Patcher. He saved my Laptop. Dell Latitude 5420.

[twist522]

so grateful to you for this patcher! I could successfully unlock the dell3440 I bought locked! the chip I patched was xmc 25rh256cxin, I used ch341b which appeared to not require 5-3.3v mod as it showed to me 3.3v on all data pins. The chip was low profile wson8 so I had to use hot air gun and solder it right on the back of my ch341b. I used NeoProgrammer V2.2.0.10 with selected configuration for chip W25Q256FV as per https://www.badcaps.net/forum/troubl...49#post3171449
A few tips for soldering first-timers:
Be careful with hot air - as I was using hot air gun for the first time I put too much air as the board was dissipating warm and I messed up my board a couple of times blowing a few small resistors away. Fortunately I was able to put it back to life while changing one small resistor and fixing one of the traces. Put more temperature but less air (~30-40%) and keep warming up the area it may take up to few minutes if you're not using pre-heating table or something.

[dryan433]

Big thumbs up to the writer of this program did the trick as every other method failed i even didnt need to remove wson8 chip just programed it still on motherboard with a t48 programmer thanks once again 😀😀😀😀😀😎😎

[tony.nicole]

Hello from France, I can't find how to post a message on the site, because I'm looking for the password for the Dell Optiplex 7010 bios code C4RKHZ3 - 8FC8 of my son's computer to change the more efficient SSD, thank you.

[peste]

Hello from France, I can't find how to post a message on the site, because I'm looking for the password for the Dell Optiplex 7010 bios code C4RKHZ3 - 8FC8 of my son's computer to change the more efficient SSD, thank you.

post S/T, full name and model, motherboard model,etc.


post the contents of the bios chip ....

The bios chip must be unsoldered from the board before writing or reading..
do not use the clip, you may have errors..if you do not have anything to unsolder it with,
solder wires between the programmer and the bios chip..

you need an SPI programmer...here is a video for example..https://www.youtube.com/watch?v=DWWi...nnel=ThisIsHow

[Funky.Monk3y]

Hello everyone,

I'm afraid I need the help of the professionals here.
I tried to reset the BIOS password on my sister's notebook using the 8FC8 patcher. After successfully patching the BIN file, I had the chip soldered back in. Unfortunately, the notebook no longer shows any response (no charging LED or anything else).

I would now try to install a clean BIOS on the chip instead of the patched one.
But before I do that, it would be really great if someone could take a look at the clean BIN file, or maybe one of you already has a working BIOS-BIN file for the device.

In the appendix, I have included the original image, the patched image from the 8FCF patcher, and the clean image I created myself.

Notebook: Dell Latitude 5440
Mainboard: LA-M401P
Rev: 1.0(A00)
Date: 2022-12-26
ST: 14W9D24

Any help is gratefully welcomed.