Announcement

Collapse
No announcement yet.

3-Beep Dell 5110

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    3-Beep Dell 5110

    Hello
    A Dell 5110 with a 3-beep problem
    When I turn on the device, the device starts with 3 beeps and after one second, it gives 3 short beeps in a row, then pauses again for one second and then 3 beeps until I turn off the device.
    Without RAM, the problem still persists
    Programmed BIOS.
    The motherboard is clean.

    #2
    Re: 3-Beep Dell 5110

    Wondering with so much information you gave, how i can help. No measurements, no steps -nothing.

    Comment


      #3
      Re: 3-Beep Dell 5110

      Originally posted by mcplslg123 View Post
      Wondering with so much information you gave, how i can help. No measurements, no steps -nothing.

      Rome has been replaced
      The CPU has been replaced
      The bios program has been run twice
      There are no signs of burns or damage to the board
      These two voltages are enough or the voltages of which parts to take
      3.3 v and 5 stb are present
      1.5 and 0.7 ram ok

      Comment


        #4
        Re: 3-Beep Dell 5110

        Consumption on dc supply
        01.With Ram
        02.Without ram

        1.8V present?? vcore present?? dramrst# present??

        Comment


          #5
          Re: 3-Beep Dell 5110

          I checked the device again with another CPU and the beep changed from 3 beeps to 5 beeps.
          I had an image on the monitor but I did not have an image on the laptop monitor. I refluxed the graphics, the image was correct, but now I do not have BACKLIGHT.
          On pin 123 LVDS
          I have 19 volts but I do not have 5 volts on pin 5, the resistance value of R4902 is 33 ohms and it is correct.

          Comment


            #6
            Re: 3-Beep Dell 5110

            LVDS PIN
            1,2,3 =DCBATOUT_LCD 19 V
            5 = LCD BRIGHTNESS 0 V
            15 = BLON_OUT_C 0 V
            26 = LCD_TST_C 0 V
            27 = 3.3 V
            38,39,40 = 3.3 V


            RN4901
            both side are 0 volt,I checked the i/o pins but they did not have voltage

            One note: PCH gets so hot that it can not be tolerated by hand

            Comment


              #7
              Re: 3-Beep Dell 5110

              up

              Comment


                #8
                Re: 3-Beep Dell 5110

                If the pch is hot then it is dead and game over.

                Comment


                  #9
                  Re: 3-Beep Dell 5110

                  ok tnx

                  Comment

                  Working...
                  X