Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Dell throttle when power supply is not recognized in bios.
-
See this how to do it but you need the information
[url]https://youtu.be/ttP1aL0u8Ws?si=qlJrz3xCusyZXedh[/url]https://See this how to do it but yo...usyZXedh[/url]
Leave a comment:
-
10 ohms on vcore is normal. Best what you can do is hd picture front and back with all resistance to ground of every coil and current sensor and which voltage are present on the coils when you have no voltage use power button and press again. Good luck then we can help...
Leave a comment:
-
-
Clean the boards. Check the ddr slot for lose pins or dirty pins...
Leave a comment:
-
-
Is it soldered memory with those black glue. Does it has slot also pressure on the ramstick while starting board does it help?...
Leave a comment:
-
-
So en1 you have only 460 ohm, better repeat the measure ment on 2kohm no reading write ol is more clear. If you have no low reading under 2kohm try to replace 1285A ic
Leave a comment:
-
Hi give the voltage on pin 1,2, 3,4,5,6 from bq chip please . How did you check the mosfets?
Leave a comment:
-
Hi it is possible the chip is bad but it most likely one off his output is shorted and let heat up the chip so please share all measurement from resistance to ground on the pinout picturen from the chip.
Regards
Leave a comment:
No activity results to display
Show More
Leave a comment: