please anyone knows how to do kbc programmin
-
Hi all,
I have done quite a lot of research into which programmer to use and despite me thinking that there should be quite a lot of documentation on this subject there is relatively little.
I am looking for a programmer for laptop EC chips (SMD and BGA).
I do have some knowledge in programming as I have used the CH341a for BIOS chips.
I am looking into the RT809H or F.
Despite there being a list of which chips the RT809 supports, it seems that there are videos of people using it for chips not on that list.
I guess I would like a programmer that can program... -
I'm able to read and write the chip by selecting a winbond IC of the same size, but when verifying it fails at around 25 percent.
I've modded the ch341a to 3.3v.
Can I update the database to include the XMC 25QH256C? -
Greetings badcaps community,
I havent done this for a long time and want to start it all again, after some evil and annyoing illness.
So I apologize in advance, if some phrases might sound a bit like gibberish or illogical to you.
Im trying my best to fully describe what I plan to achieve and hope I was choosing the right sub-forum for my new adventure.
I have a Elitebook 820 G1 and a Elitebook 840 G2 here.
These ask for a password when entering the BIOS, but boot just fine from the internal SSD.
I learned that desoldering...10-29-2024, 06:03 AM -
This is a shot in the dark, but I was just using my RT809H programmer and it got stuck in a certain state so I power cycled it. Now, the device LED just flashes quickly and does not connect to the software. I've tried to update the BIOS of it and it fails. I went so far as to remove the ROM from the programmer itself but it's some weird chip (I believe ATMEL, but I can't find any datasheet on it) so I've been unable to read the BIN from it w/ my other programmer. Chip has ATMLHC4C56BM CN written on it (I think). I'll upload an image. I have the programmer's BIN ready to program it manually. Anyone... -
Hi has anyone got the latest software for the TL866CS MiniPro EPROM programmer version 03.2.86 is installed now i have tried the update site in the programmer software but it wont connect to their website i am running windows 10
Edit found this site programmer works now http://www.xgecu.com/EN/Index.html
Comment