Got here one that charge battery normally , seems all fine ,
Once i turn in on , it will stay on for a few second with a consume about 0.40amp with this cpu he have on board , but after like 6 to 8 second it shut off . this gpu module was reballed previously . so my question is does the toshiba P200 stay on with a bad grafic module ? or even if there is no gpu module , will the machine shut off ?
im renitent to change this gpu , but all vcores are ok , cheked main S3 pins on KB all seem ok .
coils to gnd all ok
S5 state , seem all there , altough 2 of the 3 cpu fases have slightly less than 1 volts , around 0.94 should not be a big trouble since cpu is not on maximum load .
my main question is , does it stay on without module or with bad grafic ?
Once i turn in on , it will stay on for a few second with a consume about 0.40amp with this cpu he have on board , but after like 6 to 8 second it shut off . this gpu module was reballed previously . so my question is does the toshiba P200 stay on with a bad grafic module ? or even if there is no gpu module , will the machine shut off ?
im renitent to change this gpu , but all vcores are ok , cheked main S3 pins on KB all seem ok .
coils to gnd all ok
S5 state , seem all there , altough 2 of the 3 cpu fases have slightly less than 1 volts , around 0.94 should not be a big trouble since cpu is not on maximum load .
my main question is , does it stay on without module or with bad grafic ?
Comment