please help, samsung np300v3a plugin fully battery charger, unplug the charger immediately die, note "the new battery
-
Hidup yang benar2 membosankan.. hek that bak mita peng -
Re: sasmsung problem charging
hi,
i think the battery mosfet is bad try to change it, and try to swap the two mosfet if you are unable to buy a new one.Attached Files -
-
Re: sasmsung problem charging
even new battery can be totally dead not chargable. seen it many times.
but i suggest u to check charger ic pinsComment
-
Re: sasmsung problem charging
Change Or check Power adapter ,(using bench power supply Instead of adapter )
Download Schematic And check Charger IC And Components (Mosfets , Caps , Fuse ,...)
Check Voltage On Charger ICComment
-
Re: sasmsung problem charging
thank U all for your respect, I'll try to replace the first mosfet,Hidup yang benar2 membosankan.. hek that bak mita pengComment
-
Re: sasmsung problem charging
why replace? u must check if is bad. do u want to replacing all parts on board until u find one bad?Comment
-
Re: sasmsung problem charging
it's easy to change one mosfet, but it's difficult to change charging ic, my answer was based on my proper experience, because i have repaired two laptop with the same problem (platform scal 2 and scala 3)Comment
-
Re: sasmsung problem charging
its easiest than check it for error?Comment
-
Re: sasmsung problem charging
Your problem is one of the componentsplease help, samsung np300v3a plugin fully battery charger, unplug the charger immediately die, note "the new battery
RegardsComment
-
Re: sasmsung problem charging
thank you this is very helpful, I replaced all like the ones in this picture and the problem is complete, hehe, I am still in the learning stage repair laptop world, so my knowledge is still very low on a more detailed examination of each of each component, with the help of the master here I say a thousand thanks
thank you allHidup yang benar2 membosankan.. hek that bak mita pengComment
-
The charging indicator light on my ASUS X54H laptop is always on even when the charger is disconnected.
Windows also shows ''Plugged in'' when charger is not connected.
This problem started year ago gradually, when unplugging the charger the charging light took several seconds to disappear, then minutes, and now almost always on even when unplugged for an entire day.
Strangely, before sometimes immediately when plugging in the charger the charging light went away, and later came back with it connected.
If I let battery run out and say it has 3% Windows will... -
The ISL88739 & ISL88739AHRZ are a highly versatile combo battery charger
configurable for operating as either a Hybrid Power Boost (HPB)
charger or a Narrow VDC (NVDC) charger, supporting 2-, 3-, or
4-cell batteries. Both configurations allow the battery to work with
the adapter together to supply the system load when it exceeds
the adapter capability, referred to as system Turbo mode. HPB
charger configuration reverse-boosts battery energy to the system
bus to help the adapter provide the system power in Turbo mode.
NVDC charger configuration...11-05-2024, 03:28 PM -
The Bauer power tool battery charger just has to many issues with the charger over heating because I several HERCULES Hercules battery chargers that are 3 amp charge and because they have gone on quite a few times over the years before they came out with the fan cooling battery charger I going to modify one so I can charge Bauer battery packs faster than the crape battery charger that they have
Here is how this modification is going to be done I taking a 1.5 amp hour battery enclosure and gutting it removing the battery cells and replacing some Ryobi 1.5 amp hour battery pack that...05-06-2023, 12:17 PM -
Hello,
i have similar problem as https://www.badcaps.net/forum/showthread.php?t=37828
QUOTED
-It works on charger (without battery connected-only charger)
-It works on battery (without charger connected-only battery)
-& it also works when plugged in battery & charger, but it's not charging the battery
//Confirming, i have same issue, but problem started from charger, centre PIN is outputing 10V+ and jumping randomly 19V
and..
QUOTE
The IC cannot maintain the input current level... -
Hello Everyone!
I have an Acer Aspire A315-42 laptop. I generally leave it on for long time by closing down its lid (so it enters the sleep mode). Recently, it rained quite heavily in out area. And the humidity and moisture seem to be high. So one late evening, after I opened the lid and turned on the laptop, it did power on as the blue light turned on but after it booted to the desktop screen, just 5-10 seconds after both the screen and blue light went out and laptop shut down (the blue power light turned orange). And after 2-4 seconds that orange light went off and the laptop died....06-28-2025, 02:57 PM
Comment