Hi there, i am new in laptop repair n not expert. in this situation many laptop comes to me with short circuit problem. but i cannot repair that's. multimeter show many caps and MOSFET are short but when i removed those from circuit i see the parts are not short. but circuit is stil short. today a dell came with tps51125a hot prob. i check some caps and MOSFET got shorted i removed them but i cannot find actual short with success. i also removed sio but still circuit Short. pls help me for find short circuit quickly with help of schematic or any other hidden method. thank advance.
how to find short quickly??? pls help.
Collapse
X
-
Re: how to find short quickly??? pls help.
Someone had a similar question, it's discussed here a little bit.
More info would be appreciated of course!
https://www.badcaps.net/forum/showthread.php?t=35231
Related Topics
Collapse
-
by aaronkatriniHi all,
Recently picked up this GTX1650 at a local flea market for a low price and wanted to use it on my secondary PC. I first tested the card and saw the fan spin for a split second and then nothing. Immediately I thought of a short circuit. Disassembled and found a shorted SMD capacitor, injected voltage into it (1V/4A) and two Mosfets got hot immediately (QN3103 & QN3107). Desoldered these Mosfets and the card turned back to life.
Bought replacements from Aliexpress and replaced them afterwards. Tried the card but still the saw the fan spin for a split second... -
by fab13Hello everyone
Small technical problem on a Nintendo Switch lite
Here's what I noticed: the USB port has been damaged internally, with a short circuit on the power supply line to the small fuse.
After replacing the USB connector, the short circuit went away and I can't see any other short circuit in the whole motherboard.
When I charge the console, it seems to be charging: I get 15 volts and an amperage of 0.450 A.
Then, after a while, the amperage increases to 1.1 A and the BQ24193 charging chip starts to heat up, as evidenced... -
Hello.
I have seen a short circuit tester made with 3 * 9V batteries, a voltage limiter component and a resistor connected to the probes of a multimeter.
The theory is that the meter becomes sensitive enough to read very low resistances and the lowest resistance to ground on a circuit is likely to be a short circuit in that area.
Link
The Amazing $1 Short Finder Upgraded! Convert ... - YouTube
https://www.youtube.com/watch?v=0eixDdCpiO4
My multimeter isn't normally sensitive to very small resistance, but when I put a 1 mega ohm resistor... -
by smileHello,
I got ATX PSU SL-500 PSU. Images Attached.
It has blown VIPER22A, that I replaced.
Connected trough light bulb the bulb glows very bright indicating a short.
I tested every component on hot side of PCB and can't find the short circuit.
However the problem goes away removing +5VSB transformer.
The winding in questions of +5VSB transormer shows 0.08Ohms, is this normal?... -
Hello. MSI B250 Gaming M3 board, short-circuit on the power supply. Found a problematic mosfet VQ1
(N-PK616BA_PDFN8-HF) soldered it out - short circuit is gone. I replaced VQ1 + VQ5 (N-PK632BA_PDFN8-HF). VQ1 was replaced with PK618. After starting attempt VQ1 is lit again. What can be the problem? In the driver?
Schematic and Boardview here
...04-04-2025, 03:57 PM - Loading...
- No more items.
Comment