Troubleshooting Uni-T EEPROM ErrE

stj

Great Sage 齊天大聖

Join Date: Dec 2009

Posts: 31255

Country: Albion
#21

09-03-2023, 01:20 PM

Re: Troubleshooting Uni-T EEPROM ErrE

it's posted further up in post #5 ,
but you need to calibrate afterwards because every meter is a little different.
Comment

Previous 1 2 template Next

93C46 and 93C56 EEPROM

by SidneyCanadas

I tore apart my instrument cluster for my 2008 Toyota Corolla made in 2007 in Cambridge, Ontario, Canada and pcb location: IC6=EEPROM is a surface mounted device with part # of 93C46W7, some claim the EEPROM out of a Camry part # 93C56 will allow odometer to roll over 299 999 KM or miles. The data sheet for both is below:

https://cdn.badcaps-static.com/pdfs/...c6e42b20d3.pdf 2

Anyone know if the Camry one will work on my Corolla?. And which EEPROM reader/writers do you all recommend I purchase that will allow me to read the old values of the old...
- Channel: General Electronics Technical Discussion
06-14-2023, 01:16 PM
Sony XR-55A80J OLED TV 5 blinks - Troubleshooting steps

by jason123

Hi there,
I see a couple of posts related to the troubleshooting of similar TV. The one I have is acting slightly differently and I'd love your help.

So it has the 5 blinks. Previous owner got a TCON, no luck. Got a new Main board (though he didn't do the USB firmware update), again, no improvements.

I see 2 posts that are relevant:
https://www.badcaps.net/forum/troubl...j-oled-5-blink
https://www.badcaps.net/forum/troubl...g-hardware-dev...
- Channel: Troubleshooting TVs and Video Sources
10-29-2025, 02:01 PM
KDM 480W PSU upgrade succes! (opinions?)

by bauto601

Back in 2020 i bought a (2nd hand) compact ATX psu to replace my current one. My PC case only fits very short ATX power supplies so i didn't really have the choice of buying a decent 80Plus unit. The current unit is a modded YoungYear unit that i made a thread about a while ago:
A "nice" YoungYear unit? - Badcaps

The "new" unit is a KDM-M6480 480W psu, the 480W number is a typical KDM bullshit claim of course, but the 24A rating on the 12V rail seemed reasonable and the "Active PFC" claim gave me a bit of hope that this was going to be decent-ish....
- Channel: Troubleshooting Power Supplies and Power Supply Design
12-26-2023, 03:05 PM
Garage door RX unit (Cardin S38C) does not short relay to send opening signal

by CoinCoin88

Hello everyone,

I'm turning to the Badcaps community to help me troubleshoot the radio Rx card from my (old) garage door opener. While I could just ditch that card and replace the whole system, I first would like to understand "why" it suddenly stopped working, because that's just how I am wired...!

Some basics: the receiver works on a 30.875 Mhz frequency. Yes, I'm aware this is not in use anymore in a looot of places. It does not use any rolling code, it's just a regular dip-switch code that you have to set up on both the receiver and transmitter. The receiver...
- Channel: General Electronics Technical Discussion
09-15-2025, 03:36 AM
Unit runs but no speaker output kenwood KR-6030

by DrDos

I have finished my work. The new lights come on except the one for stereo, I reversed the bulbs to no affect, anyway, the unit powers on, relay clicks. I have no DC voltage in speaker outputs, I also do not have any AC in the speaker outputs. There is some faint crackling in the speaker. This unit cranks up loud so I had the volume on very low. Everything seems to be fine but I can't really check the switch until I can get sound out of the outputs. I was going to do caps for the power supplys and the tone board but thought if it was cranking loud at one time maybe just leave it alone until it...

1 Photo
- Channel: Troubleshooting Audio Equipment
09-14-2025, 09:57 PM
Loading...
No more items.

Troubleshooting Uni-T EEPROM ErrE

Comment

Related Topics