1155,H61,IO check points_emadarion
-
-
Re: 1155,H61,IO check points_emadarion
Thanks!OpenBoardView — https://github.com/OpenBoardView/OpenBoardView -
Re: 1155,H61,IO check points_emadarion
thank you very muchComment
-
Re: 1155,H61,IO check points_emadarion
thanksComment
-
Hellow guys , i really need your help here.
Lately i have a problem with My TL 866 II Plus programmer, and to be more specific many times on various IC ( Winbond, Gigadevice Mx) i get Check ID Error while i am trying to read the IC. Has already been detected without any kind of problem, but the only to read them is to uncheck every time the "Check ID " option. After that i can read it erase it and re-program it only to get another error at then end saying that can not verify the programing went well so i have program failed. So i am trying to find out what is going on? I... -
So I am trying to repair broken thunderbolt FW on X1 Yoga Gen 2. The EEPROM chip is WINBOND 25Q80DVNIG. I already do a back-up and erase. But when I try to wrote new FW, it was successfull, but when I tried to read it, it still blank. when I try to do a blank check, it gave me instant error in address 0. I already tried two CH341A, already did the 3.3v fix mod, using AsProgrammer, NeoProgrammer, Colibri, and CH341A 1.29. But the problem still occurred. What I did wrong here? Can anyone help me? Thanks in advance. Here is the log in Colibri :
...Code:Checking for blank... (Press
-
Hi all. Trying to troubleshoot issues with the Dell Laptop power supply (a lot of info here). Now I am waiting for a DC power Jack, as there is a loose contact. Want to check if the ID line of the adapter works - I have given abt 3.2 V to this line through the voltage divider, but can't see any signal on the oscilloscope. Same with the 100500% working AC adapter as well. How to initiate 1-Wire protocol transmission? As I understand, the circuit in the AC adapter should send a package for a while as soon as the supply comes to the SPID line. How to initiate this transmission correctly without... -
Hello.
I try to check some xtals wit my cheap osciloscope but i never get any good readings even when i measure working board.
with my osciloscope i generated 32kh signal and can be easily check. but on xtals measure only some voltage
How u measure it? -
Hello everybody! I have this TV that doesn't turn on, it just stays on standby and won't start. I've already checked the voltages and I have 19v, 13.33v, 4.98v and 3.33v. I disconnected the screen and Wi-Fi, but it still didn't turn on. So I would like if anyone could help check the bios or have a copy of it to help. The motherboard label model is BN94-07831V. Thank you in advance for everyone's attention....11-07-2024, 08:43 AM
Comment