TL866 II Plus Check ID Error on various IC

[dreico33]

Hellow guys , i really need your help here.

Lately i have a problem with My TL 866 II Plus programmer, and to be more specific many times on various IC ( Winbond, Gigadevice Mx) i get Check ID Error while i am trying to read the IC. Has already been detected without any kind of problem, but the only to read them is to uncheck every time the "Check ID " option. After that i can read it erase it and re-program it only to get another error at then end saying that can not verify the programing went well so i have program failed. So i am trying to find out what is going on? I have the latest version of this programmer ( 12.67v). Is there by any chance that the ICs i am trying to read and re-programm to be faulty? Or there is something wrong with my programmer.? If is something wrong with my programmer what can you suggest me?

This is the message that i am getting :

APP Version : 12.67 Model : TL866II Plus

Device : GD25B64C @SOIC8

Pins Detected Passed!

Check ID Error!

Checked ID is:0x C0 00 03

Wish to continue programming , please cancel [Check device ID] option!

Thank you very much for your time , i am looking forward for your responces.

[mon2]

You should ping the manufacturer for assistance but there may be a fault with the power supply being applied to the target devices. That is, the PCB inside this programming tool will turn ON / OFF the voltage of varying values to the target chip in the socket. Perhaps something is wrong there but the vendor offers tools to test the voltage on each pin if I recall correctly. Use that test mode to verify if you indeed have a stable voltage on the VCC pin of the flash device.