I acquired this board from an eBay seller. It is populated with all upper quality caps. No craps.
The installed Sempron 3200/200 FSB runs DDR-266 just fine, but chokes on Corsair XMS, DDR400. Go figure. Memtest runs 24+ hours on the DDR-266, but Test 5 barfs repeatedly with the Corsair.
I've twiddled voltages between stock 2.6 up to the Corsair recommended 2.75v for this pair. Matched set of 1gb as Dual Channel. Stock clocking. I even slowed down the CAS speeds... no luck.
These two memory sticks run Memtest86+ for days with zero errors in an Intel D875PBZ board. I don't think the sticks are bad... but the MSI board sure doesn't like them. I'll install the DRR-266 for the client, and run it that way... but it would be nice to use the full DDR-400.
Thoughts, anybody?
The installed Sempron 3200/200 FSB runs DDR-266 just fine, but chokes on Corsair XMS, DDR400. Go figure. Memtest runs 24+ hours on the DDR-266, but Test 5 barfs repeatedly with the Corsair.
I've twiddled voltages between stock 2.6 up to the Corsair recommended 2.75v for this pair. Matched set of 1gb as Dual Channel. Stock clocking. I even slowed down the CAS speeds... no luck.
These two memory sticks run Memtest86+ for days with zero errors in an Intel D875PBZ board. I don't think the sticks are bad... but the MSI board sure doesn't like them. I'll install the DRR-266 for the client, and run it that way... but it would be nice to use the full DDR-400.
Thoughts, anybody?
Comment