HP Z27S Horizontal Lines

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • cheebster
    Badcaps Veteran
    • May 2008
    • 373

    #1

    HP Z27S Horizontal Lines

    Hello ! I have an HP Z27S display here, top of the line 4k monitor from 2017 that sold for about 900$ Canadian, still under warranty and hp denies repair.. Anyway, that's another story.

    Here's a picture of what it does, ive torn this thing apart and i was wondering if anyone has seen a similar issue, or have any clues of what could be causing this. Bad caps in psu ? I've tried heating and freezing the boards, either psu or the input board and no difference. I've noticed the issue is also present on the OSD of the monitor, with no input signal connected. Caps seem good visually. Any pointers would be really appreciated !! thanks
    Attached Files
  • R_J
    Badcaps Legend
    • Jun 2012
    • 9535
    • Canada

    #2
    Re: HP Z27S Horizontal Lines

    why does HP deny repairs, It looks like a panel issue, A power supply problem would likely cause a problem over the whole screen not just part of it.
    Did you happen to buy it used or refurbished?

    Comment

    • cheebster
      Badcaps Veteran
      • May 2008
      • 373

      #3
      Re: HP Z27S Horizontal Lines

      It's a customer's screen and i can't find the invoice for it. HP asks for the receipt.. What a pain. Anyway, you think the panel itself is bad ? :|

      Comment

      • R_J
        Badcaps Legend
        • Jun 2012
        • 9535
        • Canada

        #4
        Re: HP Z27S Horizontal Lines

        That would be my guess, What happens if you change the screen resolution to something else, does that have any effect on the lines?

        Comment

        • cheebster
          Badcaps Veteran
          • May 2008
          • 373

          #5
          Re: HP Z27S Horizontal Lines

          Id have to swap boards to see any difference, indo have a few of these lcds here.

          What would be bad on the panel itself? buffers on the input board or something that can be replaced?

          these z27s suffer from this problem, ive seen many of them.

          Ill check for any change with resolution and report back. thanks

          Comment

          • cheebster
            Badcaps Veteran
            • May 2008
            • 373

            #6
            Re: HP Z27S Horizontal Lines

            Hello ! It seems resolution changes have no effect at all on the panel's issue. I've also tried freeze-spraying or heating the pcb that's on the panel itself and the problem is still there !

            Comment

            • cheebster
              Badcaps Veteran
              • May 2008
              • 373

              #7
              Re: HP Z27S Horizontal Lines

              Anyone has an idea if it really is a panel issue, and if so, what could be bad on a LCD Panel ? Would it be one of the components on the pcb that's on the input panel? Thanks

              Comment

              • cheebster
                Badcaps Veteran
                • May 2008
                • 373

                #8
                Re: HP Z27S Horizontal Lines

                Any input on this ? Thanks in advance

                Comment

                • cheebster
                  Badcaps Veteran
                  • May 2008
                  • 373

                  #9
                  Re: HP Z27S Horizontal Lines

                  Hello, im bumping this up.. Still have this monitor here and it'd be a shame to trash it. Anyone can chime in and has a clue what can be causing this? If its the panel, is it a faulty component on the small input board where the flat cable connects to? It needs to be fixable, its a very expensive lcd..

                  Comment

                  • captainKKK
                    Badcaps Veteran
                    • Sep 2018
                    • 287
                    • United States

                    #10
                    Re: HP Z27S Horizontal Lines

                    The panel looks ok to me, it has BL and no regional defeceits. I would have to say it's an issue on the built in T-con board.

                    Comment

                    • cheebster
                      Badcaps Veteran
                      • May 2008
                      • 373

                      #11
                      Re: HP Z27S Horizontal Lines

                      Ok, you mean the little board on the panel itself? bad components? can it be fixed?

                      Comment

                      Related Topics

                      Collapse

                      • howardc64
                        TCL 55S425 few horizontal lines, potential failure on both side of panel/buffer board
                        by howardc64
                        All left and right refers to looking from rear of TV (or looking from front with TV upside down)
                        • TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
                        • Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
                        ...
                        Yesterday, 05:17 PM
                      • Sharx112
                        ASUS VA27EHE randomly unstable
                        by Sharx112
                        Hello community. I've got an ASUS VA27EHE with a Panda LC270lf1l01 panel that started to behave strangely. A bit of intro:
                        If you power on the monitor without any inputs it turns on, displays the ASUS logo, shows no signal and goes into standby normally. When you plug it via HDMI sometimes and more recently, most of the times, it distorts the bios logo with horizontal lines, then when loading into windows 50-50 the windows emblem also is in horizontal lines. And after the system loads it almost always works properly, lol. On some rare occasions a part in the top of the monitor is being distorted...
                        03-26-2025, 03:42 AM
                      • NConstantinou
                        Hp z23n monitor shows horizontal lines
                        by NConstantinou
                        HI ALL
                        i have the above board 715G7282-P01-001-0H3S WHICH SHOWS horizontal lines.

                        on power board i noticed 3 capacitors that changed color.
                        these 3 capacitors are connected to the positive side of main capacitor.
                        i have no schematic and i do not know the values.
                        those are c921,922,923.
                        c921 is removed.
                        how can i substitute.


                        thanks...
                        03-08-2023, 07:19 AM
                      • Kikerumbo
                        Mi Curved Gaming Monitor 34" - Horizontal lines
                        by Kikerumbo
                        Hello everyone,

                        Thanks in advance for any help you can provide.

                        I have a Mi Curved Gaming Monitor 34". A few weeks ago it started to show (or not showing) horizontal lines. Of course, it's outside of the warranty period.

                        After some hours of reading and watching videos I disassembled the monitor and checked the ribbons that go from the TCON board to the panel PCB. If I disconnect the ribbon for the right side of the panel, the other half shows a perfect image. I ordered a "new" TCON, installed it and the issue persists so that tells me it must...
                        03-14-2024, 02:48 PM
                      • reessi
                        ACER BM320 Monitor - Horizonal Flickering Lines After a While
                        by reessi
                        Hello,

                        The monitor started off showing flickering thin (1 pixel) lines horizontally every say 3mm..

                        They are black on the right and gradually fade to nothing on the far left.
                        They start either after 5 mins or up to 2 hours after so annoying for testing.
                        They flicker continuously very fast! With a slight pause milli-second every second.

                        Initially I cleaned the LVDS cable and connected to the T-Con and then it worked fine for 3 weeks but not sure if this was just co-incidence.

                        I tested each half by removing the first the left flex from...
                        06-03-2025, 09:58 AM
                      • Loading...
                      • No more items.
                      Working...