I have this kill-a-watt device and the lcd ribbon is bad. Where can I buy the replacement ? TIA
Attached Files
-
-
Re: Where to buy this LCD ribbon
forget it, you dont have the equipment to bond it to the board or glass.
depending on how it fits, you may be able to use zebrastrip instead - maybe. -
Re: Where to buy this LCD ribbon
as stj said zebrastrip -> https://en.wikipedia.org/wiki/Elastomeric_connector is your best bet or maybe some Z tape altough in this case i dont think z tape will helpComment
-
Anyone know if the ribbon cables are standard across laptops cases like in a PC, or are they proprietary to each manufacturer? I damaged the one that runs between the MB and the power / HDD / Battery Status Indicator LED Circuit Board. The Dell SKU/DPN: ADM70LED. I just need help finding a replacement. Could I possibly use a similar cable from a donor laptop?
-
I have a Quantum SuperLoader robotic tape library that uses an IBM LTO 7 tape drive which is constantly complaining that it needs cleaning. If you insert a cleaning tape, it performs the clean and resets the cleaning counter to 0 hours. It should only require cleaning every 50 or so working hours but after as little as just 1 hours use it requests cleaning. We've purchased a new cleaning tape along with new LTO backup tapes but that has not resolved the problem.
I have taken the library apart and can see no noticeable signs of dust inside. I have removed the tape drive from the... -
Problem
This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached.... -
Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.
The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.
Original T-con:
Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.
First replacement T-con:
I thought it might be t-con and ordered new t-con from china(supposedly tested)... -
I am trying to fix a tablet that someone botched the ffc/fpc connector on as circled in the picture. When buying a replacement connector I see the connectors are categorized by number of pins and pitch but how do I determine what mine is to find an exact replacement. Not sure if it means anything, but beside the connector it has written a number 1 on one side and 51 on the other side which is also written on the ribbon flex...
Comment