Hello everyone. I have been reading this forum for a quite wile now, loads of good information.
However i have a quick question regarding my old Hanns-G monitor.
The monitor turns off if i plug it via HDMI (blue light is constantly ON).
Now if i use analogue (VGA) there's two green (sometimes one) lines appear on the right side of the monitor as well as the picture itself is wavy.
It needs good 30 mins before monitor back to normal (waves and green light disappear).
Now after monitor warms up (after an hour or so) i can sometimes switch the cable to HDMI and monitor works just fine.
I have tested voltages while monitor is on stand-by (i get steady 4.98V on one output) in addition i get +12 and +14 if the monitor is in its active state.
What do you think can cause such a behavior?
Thank you and sorry for my English
However i have a quick question regarding my old Hanns-G monitor.
The monitor turns off if i plug it via HDMI (blue light is constantly ON).
Now if i use analogue (VGA) there's two green (sometimes one) lines appear on the right side of the monitor as well as the picture itself is wavy.
It needs good 30 mins before monitor back to normal (waves and green light disappear).
Now after monitor warms up (after an hour or so) i can sometimes switch the cable to HDMI and monitor works just fine.
I have tested voltages while monitor is on stand-by (i get steady 4.98V on one output) in addition i get +12 and +14 if the monitor is in its active state.
What do you think can cause such a behavior?
Thank you and sorry for my English
Comment