Samsung SyncMaster B2330 Black screen

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    Any Ideas? sorry again for the bump but I didn't think I should open a new thread because I already started the other portion on this thread

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    one little problem now, the monitor was clicking and making a weird noise and then this happened. is the monitor trash now? I feel like it is but maybe their is a simple fix. The ribbon cables off the motherboard post ccfl installation, it was making a weird noise that was rapid clicking and the screen had changing lines of color so I took it apart again and these ribbons came disconnected the contacts are smaller than a hairs with... idk what I should do now.. picture is posted
    Attached Files
    Last edited by malexry; 04-18-2015, 11:40 AM.

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    Thank you both budm and lumberjack and anyone else who helped! ordered 2 ccfl assemblies for 11bucks (from hongkong :/) should be here hopefully within the month.. then we will see if it has worker or not! thanks again!

    Leave a comment:


  • Lumberjack777
    replied
    Re: Samsung SyncMaster B2330 Black screen

    Originally posted by malexry
    that is problematic, they were actually cracked when I took them out... is their any other way that I can power on the monitor? any at all?
    Yes, there is. At the electronics recycle center where I volunteer; we sometimes get a decent monitor with bad bulbs. But it would be too costly, and time consuming to repair. So we grab an extra set of ccfl's about the same length and plug them into the inverter where the bad ccfl's are. This prevents the protection circuit from shutting the monitor down. And it's still safe to operate. Then we duct tape the ccfl's to the lcd panel. This means the lcd monitor will now be running on just those 2 good ccfl's inside. And that's often still plenty bright enough. We tell a buyer that it only has 2 bulbs lighting inside, and give them a discount. You could probably find cheap used ccfl's at your local lcd/tv/electronics recycle center.
    Last edited by Lumberjack777; 04-03-2015, 11:56 PM.

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    that is problematic, they were actually cracked when I took them out... is their any other way that I can power on the monitor? any at all?

    Leave a comment:


  • budm
    replied
    Re: Samsung SyncMaster B2330 Black screen

    You can make two test lamps so it will keep the Inverter circuit from shutting down.
    https://www.badcaps.net/forum/showthread.php?t=19987

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    Is their anyway I can run the monitor before buying the CCFLs? it has 2 of the 4 still in it functioning and I would like to confirm that that was the only problem before I spend 40 dollars on new bulbs.

    Leave a comment:


  • budm
    replied
    Re: Samsung SyncMaster B2330 Black screen

    4mm Dia will be too big if the original is only 2mm.

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    one more question, the ccfl 'fit' in the display are 2mmx470mm Their are two of them! I found a 4mmx470mm. could I replace the them with that one?

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    ok then.. I just think that I might have severly damaged the pixels and I don't want to buy new lights if the pixels are gone.. but thanks for that info I love u budm! will post results when I get new ccfl!
    Last edited by malexry; 04-02-2015, 11:59 AM.

    Leave a comment:


  • budm
    replied
    Re: Samsung SyncMaster B2330 Black screen

    Try this one: http://lcdparts.net/

    "can I run the monior with 2 out of the 4 ccfl lights to make sure I did not damage the screen in disassembly?" No, the protection circuit will kick in.

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    can I run the monior with 2 out of the 4 ccfl lights to make sure I did not damage the screen in disassembly?

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    budm I could not love u more right now. however ccfl does not have that size ccfl. I need a 2mmx470mm and cannot find them.

    Leave a comment:


  • budm
    replied
    Re: Samsung SyncMaster B2330 Black screen

    Ccflwarehouse:
    http://www.ccflwarehouse.com/?gclid=...FdBefgodDnUAkQ
    Last edited by budm; 04-02-2015, 11:30 AM.

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    your so FREACKING SMART! I could the coulpret! I need some new ccfls. where should I look for them?
    Attached Files

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    here are some pictures of the display. their is a little yellowish mark on the corner, however it is a different corner than the one with the triangle
    Attached Files

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    I cant get the file to upload with other files but this time im going to try to upload a close up of that only.
    Attached Files

    Leave a comment:


  • budm
    replied
    Re: Samsung SyncMaster B2330 Black screen

    "the upper right hand corner( when the monitor gets hot) it has a black triangle that grows as the monitor gets hotter" So where is this black triangle?

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    im going to take apart the display right now if I can and see what the lights look like!

    Leave a comment:


  • malexry
    replied
    Re: Samsung SyncMaster B2330 Black screen

    forgot the pics... their may be some duplicates in their but I just wanted to make sure I got all the ones I could find. thanks guys!

    should I begin to disassemble the actual display? would that help at all? I am more in the programming side of computers so all this hardware is like Latin to me lol
    Attached Files
    Last edited by malexry; 04-02-2015, 10:52 AM. Reason: pictures didnt upload correctly

    Leave a comment:

Related Topics

Collapse

  • Chrissygizmo
    Samsung UE55JU6800K half screen dark
    by Chrissygizmo
    Hello everyone, I’ve just been given a Samsung UE55JU6800K smart tv as it had white spots on the screen due to the led lenses falling off. After refitting them & putting the tv back together I thought it was a nice easy fix for a free bedroom tv , then I tried it before screwing the back into place. I realised that the right side of the screen was darker than the other side, I removed the screen again as I thought the backlights had failed but they are fine.
    I put the screen back in place & turned it back on . The screen seemed to be ok again but different screens on the same...
    02-10-2025, 12:33 AM
  • Chrissygizmo
    samsung galaxy ao2s very temperamental after screen replaced
    by Chrissygizmo
    Hi , I've recently replaced the screen in my Samsung galaxy ao2s, at first it wouldn't even turn on, it had the charging symbol on the screen when plugged in but the green circle wasn't going around to show it charging....
    Ive eventually managed to get it on and working but it's very temperamental...

    The battery icon always reads as 50% , when the phone goes into lock screen mode i sometimes can't get the screen back on unless I plug the charger in to get it to light up, also it keeps putting the camera app on.. u think it could be something to do with the side buttons. ...
    05-26-2024, 12:05 AM
  • JunkmanJimbo
    Samsung UN55J6200AFXZA Splash Screen Comes up, goes out, screen flashes one time and won't turn off
    by JunkmanJimbo
    Samsung UN55J6200AFXZA Splash Screen Comes up, goes out, screen flashes one time and then tv won't turn off.
    No picture. No sound that I can tell. Backlights are on and have been checked. Flashlight test no image on screen. I replaced the Eprom chip hoping that was the problem but nothing changed.
    Please help. Thanks in advance!
    08-12-2025, 11:45 AM
  • Kiberge
    Samsung LH82QENELGC/EN Help needed - Static line on screen
    by Kiberge
    HI guys!

    I've got a Samsung LH82QENELGC/EN with a problem and need some advice and I hope this is the forum to use?
    I'm from Norway so I'd like to apology in advance if my description of the fault is kind of simple or the names on the components are way off. 😊

    the TV is powering up, working as normally and picture is all good, except a 1.5-inch-wide vertical line of snow/static across the screen.


    This TV is a Signage Display/Public Display version and it's been used at my work for 4-5 years showing commercials 24/7. The fault occurred when...
    04-22-2024, 11:28 AM
  • Ryan.man
    Macbook 2017 with touchbar (A1706) won't turn on after removing the screen
    by Ryan.man
    Hello everybody! Posting this in hopes somebody has some expertise that leads to a clear path of troubleshooting that saves me a lot of time!

    My macbook has the flex cable problem, the one that prevents the screen turning on. Ive been dealing with this for the last 3 years. Last year it went dead and I managed to fix it following youtube tutorials. But my fix wasnt the best, the problem returned a month later. This week, it went dead again. I again tried to fix it.

    This time the original cable broke too close to the screen, it can't be fixed without tearing the screen...
    02-04-2025, 12:23 PM
  • Loading...
  • No more items.
Working...