Re: Recommendations of quality soldering station and (separate) hot air station
That’s the only thing I could find out back then.
That’s the only thing I could find out back then.
-
-
Re: Recommendations of quality soldering station and (separate) hot air station
then maybe i'll get a T3a and a micro-pencil and make a splitter with a swutch - save wearing the plugs outComment
-
Re: Recommendations of quality soldering station and (separate) hot air station
Why not a dual station setup and have a T245 on one side and the other one on the other side? No change required.Comment
-
Re: Recommendations of quality soldering station and (separate) hot air station
they make one - it's fucking expensive!Comment
-
Re: Recommendations of quality soldering station and (separate) hot air station
Nothing is cheap these days…Comment
-
I have been working on this concept for quite some time now with limited success but recently I found a switching power supply that is setup for the voltage that this soldering station needs to operate at however it also needs part of the secondary circuit from the original switching power because you need several voltage rails
I once tried to get a ZD-915 desoldering station to work on a 18 volt battery power supply but unfortunately things did not go well but I did find a work around but I might try this idea again but going at a little differently more about this another time... -
hello.
A few months ago,I have purchased 0.1mm Soldering Iron Tip of below aliexpress link,But I noticed that It is totally impossible to use this 0.1mm iron tip in the T12 soldering station
https://ko.aliexpress.com/item/4001275635593.html
Is there any good soldering station which is possible to use 900M-TJ-I tip and have inexpensive or reasonable price in aliexpress?
Any reply would be appreciated. -
I purchased this soldering station when it was on sale at amazon. It had a slew of one star reviews, but the price was low enough that even if the controller and PSU were toast, the handle tips and stand were worth more than the price. All of the reviews mentioned that the unit was either DOA, or died on the first use. I looked on Aliexpress and the first clue was that KSGER still sold the 220V version of this station, but all of the 110V versions had been discontinued. I figured That there was a problem with the 110V on the power suppply and the controller would be fine.
I am... -
HI,
Have a QUICKO soldering station with no numbers for the model ... (think it's a KSGER or similar copy)
All worked nice, till some day it heats the iron till it was RED (HOT) ...
Turned it off, and tryed today again, and all the same, even with a second iron ...
The display shows that the iron is not connected, like not inserted in the handle ...
The second thing is that it has 6 pins connector and can't find a handle that is similar for my station ...
Has someone some advice what to do, where to look, even how to... -
Hi
I have an Ersa rds 80 soldering station which has developed a fault and just showing err on display
I have found a burnt resistor on pcb can anyone help me identify this resistor if you have a circuit diagram or similar unit
The printed circuit board markings are rd80 ver 2.0 and the resistor in question is R6
Many thanks...
Comment