Not sure if this is the right site but any help is appreciated.
I have a small 2 horsepower 120VAC portable air compressor that starts fine on the line voltage in my shop. I have used it many times on a generator (5000 watt)but now it will not start when the pressure switch calls for it to run. The motor turns slowly until it trips out. If I discharge the air then compressor will start but even then it seems to struggle more than when it is connected to house current. I have tried it on two different generators with the same results. Any ideas?
I have not tested the capacitor because it is starting fine on house current but here is the capacitor info:
XUFENG
CBB60 150uF +/- 5%
250VAC C SH P0
25/70/21 50/60HZ
09.2008
Thanks for your help,
David Cochran
I have a small 2 horsepower 120VAC portable air compressor that starts fine on the line voltage in my shop. I have used it many times on a generator (5000 watt)but now it will not start when the pressure switch calls for it to run. The motor turns slowly until it trips out. If I discharge the air then compressor will start but even then it seems to struggle more than when it is connected to house current. I have tried it on two different generators with the same results. Any ideas?
I have not tested the capacitor because it is starting fine on house current but here is the capacitor info:
XUFENG
CBB60 150uF +/- 5%
250VAC C SH P0
25/70/21 50/60HZ
09.2008
Thanks for your help,
David Cochran
Comment